2009 Toyota Sequoia Navigation Manual - Page 238

08 05.16 AUDIO/VIDEO SYSTEM Audio/video remote controls (steering switches) 3. "ƜƝ" switch Radio This switch has the following features- To select a preset station: Quickly push and release the "Ɯ" or "Ɲ" side of the switch. Do this again to select the next preset station. To seek a station: Push and hold the "Ɯ" or "Ɲ" side of the switch until you hear a beep. Do this again to find the next station. If you push the switch on either side during the seek mode, seeking will be cancelled. To step up or down the frequency, push and hold the switch even after you hear a beep. When you release from the switch, the radio will begin seeking up or down for a station. Do this again to find the next station. XMr Satellite Radio∗- To select a preset channel, push the "Ɯ" or "Ɲ" side of the switch. Repeat until a desired channel is found. ∗: Use of satellite radio requires XMr tuner and service. Contact your Toyota dealer for details. XS00323 Some parts of the audio system can be adjusted using the switches on the steering wheel. Details of the specific switches, controls, and features are described below. 1. Volume control switch 2. "MODE" switch 3. "ƜƝ" switch 1. Volume control switch Push "+" side to increase the volume. The volume continues to increase while the switch is being pressed. Push "−" side to decrease the volume. The volume continues to decrease while the switch is being pressed. 2. "MODE" switch Push "MODE" switch to select an audio mode. Each push changes the mode sequentially if the desired mode is ready to use. To turn the audio/video system on, push the "MODE" switch. To turn the audio/video system off, push and hold the "MODE" switch until you hear a beep. 218