2010 Toyota Sienna Warranty, Maitenance, Services Guide - Page 49

Maintenance Log 90,000 Miles or 108 Months Re-torque drive shaft bolt (4WD) Re-torque propeller shaft bolt (4WD) Replace cabin air filter Replace engine air filter Replace engine oil and filter 1 Rotate tires Inspect the following: Automatic transmission fluid Ball joints and dust covers Brake lines and hoses Brake linings/drums and brake pads/discs 4 Drive belts Drive shaft boots Engine coolant 5 Exhaust pipes and mountings Front differential oil __ Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses __ Fuel tank cap gasket __ Radiator and condenser __ Rear differential oil (4WD) __ Steering gear box __ Steering linkage and boots __ Transfer case oil (4WD) Additional Maintenance Items for Special Operating Conditions Driving on dirt roads or dusty roads: 2 Tighten nuts and bolts on chassis and body Driving while towing: Replace rear differential oil (4WD) Replace transfer case oil (4WD) Tighten nuts and bolts on chassis and body MAINTENANCE DEALER SERVICE VERIFICATION: DATE: MILEAGE: 1 Reset the oil replacement reminder light (ЉMAINT REQDЉ) or the message ЉOIL MAINTENANCE REQUIREDЉ on the multi-information display after engine oil replacement. Perform these service items only if you drive primarily under the conditions indicated. 3 Includes operating on roads on which road salt has been applied. 4 Inspect thickness measurement and disc runout. 5 Refer to ЉEngine CoolantЉ in the ЉExplanation of Maintenance ItemsЉ section in the back of this guide for more information. 2 Maintenance Log 47