2010 Toyota Sienna Warranty, Maitenance, Services Guide - Page 53

Maintenance Log 120,000 Miles or 144 Months Re-torque drive shaft bolt (4WD) Re-torque propeller shaft bolt (4WD) Replace cabin air filter Replace engine air filter Replace engine oil and filter 1 Replace spark plugs 4 Rotate tires Inspect the following: Automatic transmission fluid Ball joints and dust covers Brake lines and hoses Brake linings/drums and brake pads/discs 5 Drive belts Drive shaft boots Engine coolant 6 Exhaust pipes and mountings Front differential oil __ Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses __ Fuel tank cap gasket __ Radiator and condenser __ Rear differential oil (4WD) __ Steering gear box __ Steering linkage and boots __ Transfer case oil (4WD) Additional Maintenance Items for Special Operating Conditions Driving on dirt roads or dusty roads: 2 Tighten nuts and bolts on chassis and body Driving while towing: Replace automatic transmission fluid Replace front differential oil Replace rear differential oil (4WD) Replace transfer case oil (4WD) Tighten nuts and bolts on chassis and body DEALER SERVICE VERIFICATION: MAINTENANCE DATE: MILEAGE: 1 Reset the oil replacement reminder light (ЉMAINT REQDЉ) or the message ЉOIL MAINTENANCE REQUIREDЉ on the multi-information display after engine oil replacement. 2 Perform these service items only if you drive primarily under the conditions indicated. 3 Includes operating on roads on which road salt has been applied. 4 It is imperative to use the DENSO-manufactured spark plug FK20HR11, or equivalent, which enables full engine performance, or equivalent. Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty. 5 Inspect thickness measurement and disc runout. 6 Refer to ЉEngine CoolantЉ in the ЉExplanation of Maintenance ItemsЉ section in the back of this guide for more information. Maintenance Log 51