2010 Toyota Tundra Regular Cab Warranty, Maitenance, Services Guide - Page 124

Maintenance Log 57,500 Miles or 69 months Replace engine oil 1 DEALER SERVICE VERIFICATION: DATE: MILEAGE: 60,000 Miles or 72 months Lubricate propeller shaft (4WD) Re-torque propeller shaft bolt Replace cabin air filter Replace engine air filter Replace engine oil and filter Rotate tires 1 4 Replace spark plugs (1GR-FE engine only) Inspect the following: Automatic transmission fluid Ball joints and dust covers Brake lines and hoses Brake linings/drums and brake pads/discs 5 Drive belts 6 Drive shaft boots (4WD) Engine coolant 7 Engine valve clearance 8 __ Exhaust pipes and mountings __ Front differential oil (4WD) __ Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses __ Fuel tank cap gasket __ Radiator and condenser __ Rear differential oil __ Steering gear box __ Steering linkage and boots __ Transfer case oil (4WD) NOTE: Driving in heavy traffic, on dirt roads or in urban, dusty or desert areas may shorten the life of the cabin air filter. Replacement may be needed if you notice reduced air flow from the air conditioner and heater or if the windows fog easily when you use the ЉFreshЉ mode. Consult your dealer if any of these conditions occur. Additional Maintenance Items for Special Operating Conditions Driving on dirt roads or dusty roads: Tighten nuts and bolts on chassis and body 2 MAINTENANCE Driving while towing: Replace automatic transmission fluid Replace front differential oil (4WD) Replace rear differential oil Replace transfer case oil (4WD) Tighten nuts and bolts on chassis and body DEALER SERVICE VERIFICATION: DATE: MILEAGE: 1 Refer to ЉEngine Oil and FilterЉ in the ЉExplanation of Maintenance ItemsЉ section in the back of this guide for more information. Perform these service items only if you drive primarily under the conditions indicated. 3 Includes operating on roads on which road salt has been applied. 4 Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty. 5 Inspect thickness measurement and disc runout. 6 Initial inspection at 60,000 miles/72 months. Inspect every 15,000 miles/18 months thereafter. 7 Refer to ЉEngine CoolantЉ in the ЉExplanation of Maintenance ItemsЉ section in the back of this guide for more information. 8 Check for tappet noise and engine vibration and adjust if necessary, 1GR-FE engine only. 2 Maintenance Log 45