2011 Toyota Tacoma Double Cab Warranty, Maitenance, Services Guide - Page 54

2011 Toyota Tacoma Double Cab Manual

Page 54 highlights

Maintenance Log 120,000 miles or 144 months Check installation of driver's floor mat Inspect and adjust all fluid levels Lubricate propeller shaft (4WD models and all Prerunners with 4 cylinder engines) Re-torque propeller shaft bolt Replace cabin air filter Replace engine air filter Replace engine oil and oil filter1 Replace rear differential oil (Prerunner and 4WD vehicles with optional limited slip differential only) Replace spark plugs 4 Rotate tires Inspect the following: Ball joints and dust covers Brake lines and hoses Brake linings/drums and brake pads/discs 5 Drive belts Drive shaft boots (4WD) Engine coolant 6 Engine valve clearance 7 Exhaust pipes and mountings Front differential oil (4WD) Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses __ Fuel tank cap gasket __ Radiator and condenser __ Rear differential oil (except Prerunner and 4WD vehicles with optional limited slip differential only) __ Steering gear box __ Steering linkage and boots __ Transfer case oil (4WD) __ Transmission fluid or oil Additional Maintenance Items for Special Operating Conditions Driving on dirt roads or dusty roads: 2 Driving while towing: __ Replace transfer case oil (4WD) __ Tighten nuts and bolts on chassis and body Replace front differential oil (4WD) Replace rear differential oil Replace transfer case oil (4WD) Replace transmission fluid or oil Tighten nuts and bolts on chassis and body MAINTENANCE DEALER SERVICE VERIFICATION: DATE: MILEAGE: 1 2 3 4 5 6 7 Reset the oil replacement reminder light ("MAINT REQD") or the message "OIL MAINTENANCE REQUIRED" on the multi-information display after maintenance at every 5,000 miles. Perform these service items only if you drive primarily under the conditions indicated. Includes operating on roads which road salt has been applied. Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty. Inspect thickness measurement and disc runout. Refer to "Engine Coolant" in the "Explanation of Maintenance Items" section in the back of this guide for more information. Check for tappet noise and engine vibration and adjust if necessary, 1GR-FE engine only. Maintenance Log 53

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.