2012 Toyota Prius Navigation Manual - Page 338

2. ADVANCED PARKING GUIDANCE SYSTEM OPERATING PROCEDURE CAUTION ● When backing up, be sure to check your surroundings and behind the vehicle for safety, and back up slowly, depressing the brake pedal to control vehicle speed. ● If you seem likely to hit nearby vehicles, obstacles or people, depress the brake pedal to stop the vehicle, then disable the system by touching on the screen. WHEN THE PRE-SUPPORT FUNCTION IS IN USE 1 2 Check that the assist mode switch is ON. With the vehicle speed at less than 9 mph (15 km/h) and the vehicle on the near side of the parking space, press the pre-support switch twice. Confirm that the display has switched to the "Back-In Mode" screen. As the system only assists with parking in a set target parking position, there are times when the system will be unable to render this assistance, depending on factors such as road surface or vehicle condition, or the distance to the set target parking position. Use the system with full understanding of the fact. If a message is displayed while maneuvering, follow the procedures outlined in "WHAT TO DO WHEN THIS SORT OF MESSAGE IS DISPLAYED" on page 353. The illustrations here describe the procedure for pulling into a parking space on the right. For pulling into a parking space on the left, substitute left for right and vice versa in all steps. The operating method differs depending on whether or not the pre-support function is in use. Press the pre-support switch twice Sensor detection range PERIPHERAL MONITORING SYSTEM 9 The mode will switch with each press of the pre-support switch. If the shift position is in "P" or if the vehicle speed is 9 mph (15 km/h) or above, two beeps will sound when the pre-support switch is pressed, and the display will not change. (If the shift position is in "R", the display will not change.) 331 PRIUS v (US) NAVI 47675U 11.09.08 12:54