Home » Acer Manuals » Desktops » Acer Aspire SA60 » Manual Viewer

Acer Aspire SA60 Aspire SA60 and Power S260 Service Guide - Page 36

M, 3.5 - inch, VGA/EGA, All, but Keyboard, Parameter, Description, Options - windows 7

Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

Parameter IDE Secondary Channel Master IDE Secondary Channel Slave Drive A Drive B Video Halt On Base Memory Extended Memory Total Memory Description Options Allows you to configure the hard disk drive connected to the master port of IDE channel 1. To enter the IDE Channel 1 Master setup, press [Enter]. The IDE CD-ROM is always automatically detected. IDE Device Model Number: None Allows you to configure the hard disk drive connected to the slave port of IDE channel 2. To enter the IDE Channel Secondary Master setup, press [Enter]. The IDE CD-ROM is always automatically detected. IDE Device Model Number: None Allows you to configure your floppy drive A. None 360 KB, 5.25-inch 1.2 MB, 5.25-inch 720 KB, 3.5-inch 1.44M, 3.5 - inch 2.88 MB, 3.5-inch Allows you to configure your floppy drive B. None 360 KB, 5.25-inch 1.2 MB, 5.25-inch 720 KB, 3.5-inch 1.44M, 3.5 - inch 2.88 MB, 3.5-inch This item specifies the type of video card in use. The default setting is VGA/EGA. Since current PCs use VGA only, this function is almost useless and may be disregarded in the future. VGA/EGA CGA40 CGA80 Mono This parameter enables you to control the system stops in case of Power On Self Test errors (POST). All Errors No Errors All, but Keyboard All, but Diskette All, by Disk/Key Refers to the option of memory that is available to standard DOS programs. DOS systems have an address space od 1MB, but the top 384KB (called high memory) is reserved for system use. This leaves 640 KB of conventional memory. Everything above 1MB is either extended or extended memory. The BIOS POST will determine the amount of base (or conventional) memory installed in the sytem. Memory above and beyond the standard 1MB of base memory that DOS supports. Extended memory is only available in PCs with an Intel 80286 or later microprocessor. Extended memory is not configured in any special manner and is therefore unavailable to most DOS programs. However, MS Windows and OS/2 can use extended memory. The BIOS determines how much extended memory is present during the POST. Total based and extended memory, and I/O ROM total memory of the system. 384KB available to the system. 28 Chapter 2

Section	Page
Aspire SA60/AcerPower S260 Service Guide	1
Revision History	2
Copyright	3
Disclaimer	3
Conventions	4
Preface	5
T.O.C	6
S.G_CH1_System Specifications	9
System Specifications	9
Overview	9
Features	10
Mainboard Placement	13
Block Diagram	15
Aspire SA60 Front Panel	16
Aspire SA60 Rear Panel	17
AcerPower S260 Front Panel	18
AcerPower S260 Rear Panel	19
System Peripherals	20
Mouse (PS/2 or USB, manufacturing option)	20
Keyboard (PS/2 or USB, manufacturing option)	20
Speakers	21
Acer eRecovery	22
Create backup	22
Restore from backup	22
Create factory default image CD	22
Re-install bundled software without CD	23
Change Password	23
Acer disc-to-disc recovery	24
Restore without a Recovery CD	24
Multilingual operating system installation	24
Hardware Specifications and Configurations	25
Power Management Function (ACPI support function)	30
S.G_CH2_System Utilities	31
System Utilities	31
Entering Setup	32
Product Information	34
Standard CMOS Features	35
Advanced BIOS Features	37
Advanced Chipset Features	39
DRAM Clock/Timing Control	40
AGP & P2P Bridge Control	41
Onchip AGP Control	42
Integrated Peripherals	43
SIS OnChip IDE Device	44
SIS OnChip PCI Device	45
Onboard Super IO Device	46
Power Management Setup	47
PM Wake Up Events	49
PnP/PCI Configuration	51
IRQ Resources	52
PC Health Status	53
Frequency/Voltage Control	54
Load Default Settings	55
Set Supervisor/User Password	56
Save & Exit Setup	57
Exit Without Saving	58
S.G_CH3_Machine Disassembly and Replacement	59
General Information	60
Before You Begin	60
Standard Disassembly Procedure	61
Opening the System	61
Removing the Front Panel	62
Removing the Cables from Mainboard	62
Disconnect the Cables from Device	64
Removing the DIMM	65
Removing the Heatsink	65
Removing the CPU	65
Removing the System Fan	65
Removing the Power Supply	66
Removing the HDD	66
Removing the FDD and Card Reader	66
Removing the ODD	67
Removing the I/O Module	67
Removing the Card Reader	67
Removing the Mainboard	68
Removing the Mainboard	68
S.G_CH4_Troubleshooting	69
Troubleshooting	69
Power-On Self-Test (POST)	70
POST Check Points	71
POST Error Messages List	77
Error Symptoms List	79
S.G_CH5_Jumper and Connector Information	84
Jumper and Connector Information	84
Rear Panel I/O	84
AUDIO JACK	84
Print Port	85
Serial Port	86
PS2-KBMS	87
Dual USB & RJ45 CONN	88
Dual USB	89
Front Panel I/O	90
Front Audio Header	91
Front USB Header	92
Conn & Jump Setting	93
IDE Connector	93
Floppy Connector	94
CD-IN	95
SYS FAN Connector	95
CPU FAN Connector	95
Clear CMOS	95
S.G_CH6_FRU	96
FRU (Field Replaceable Unit) List	96
Exploded Diagram	97
Parts	98
S.G_AppA_Model Definition and Configuration	104
S.G_AppB_Test Compatible Components	105
Test Compatible Components	105
Microsoft Windows XP Home Environment Test	106
S.G_AppC_Online Support Information	111

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.