Acer Aspire T100 Aspire T100/SV Service Guide - Page 34

Parameter IDE Primary Channel Slave IDE Secondary Channel Master IDE Secondary Channel Slave Drive A Drive B Video Halt On Base Memory Description Options Allows you to configure the hard disk drive connected to the slave port of IDE channel To enter the IDE Primary Slave setup, press [Enter]. The IDE CD-ROM is always automatically detected. IDE Device Model Number: None Allows you to configure the hard disk drive connected to the master port of IDE channel 2. To enter the IDE Secondary Master setup, press [Enter]. The IDE CD-ROM is always automatically detected. IDE Device Model Number: None Allows you to configure the hard disk drive connected to the slave port of IDE channel 2. To enter the IDE Secondary Slave setup, press [Enter]. The IDE CD-ROM is always automatically detected. IDE Device Model Number: None Allows you to configure your floppy drive A. 1.44 MB, 3.5-inch None 360 KB, 5.25-inch 1.2 MB, 5.25-inch 720 KB, 3.5-inch 2.88 MB, 3.5-inch Allows you to configure your floppy drive B. 1.44 MB, 3.5-inch None 360 KB, 5.25-inch 1.2 MB, 5.25-inch 720 KB, 3.5-inch 2.88 MB, 3.5-inch This item specifies the type of video card in use. The default setting is VGA/EGA. Since current PCs use VGA only, this function is almost useless and may be disregarded in the future. VGA/EGA CGA40 CGA80 Mono This parameter enables you to control the system stops in case of Power On Self Test errors (POST). All Errors No Errors All but Keyboard All but Diskette All by Disk/Key Refers to the option of memory that is available to standard DOS programs. DOS systems have an address space od 1MB, but the top 384KB (called high memory) is reserved for system use. This leaves 640 KB of conventional memory. Everything above 1MB is either extended or extended memory. Chapter 2 27