Acer TravelMate 210 TravelMate 210 Service Guide - Page 38

Startup Configuration The Startup Configuration screen contains parameter values that define how your computer behaves on system startup. Startup Configuration Boot Display Screen Expansion Hotkey Beep Fast Boot CPU Power Management Mode---------- [Both] [Enabled] [Enabled ] [Enabled ] [ Auto ] Boot Drive Sequence: 1st 2nd 3rd [Floppy Disk] [CD-ROM] [Hard Disk] Page 1/1 ↑↓ = Move highlight bar, ←→ = Change setting, F1 = Help The following table describes the parameters in this screen. Settings in boldface are the default and suggested parameter settings. Parameter Boot Display Screen Expansion Hotkey Beep Fast Boot CPU Power Management Mode Boot Drive Sequence Description Options Sets the display device on boot-up. When set to Auto, the computer automatically determines the display device when the computer starts up. If an external display device (e.g., monitor) is connected, it becomes the boot display; otherwise, the computer's display screen is the boot display. When set to Both, the computer outputs to both the computer display screen and an external display device if one is connected. Both or Auto When set to enabled, the screen will automatically Enabled or Disabled adjust the display to fit the screen when the resolution is set to 640 x 480. When enabled, the computer gives off a beep when a Enabled or Disabled hotkey (key combination is pressed). Allows you to define your system's booting process; Enabled or Disabled whether to skip some POST routines or proceed with the normal booting process. Auto or Disabled Specifies the order in which the computer starts up from. See the section below. 1st: Floppy Disk, 2nd: CD-ROM, 3rd: Hard Disk 32 Chapter 2