Acer TravelMate 210 TravelMate 210 Service Guide - Page 39
Onboard Device Configuration, Setting the Boot Drive Sequence
View all Acer TravelMate 210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Setting the Boot Drive Sequence The Boot Drive Sequence section lists boot priorities (1st, 2nd and 3rd ) for bootable drives in your computer. For example, the default value (1st:Floppy Disk, 2nd:CD-ROM and 3rd:Hard Disk) tells the computer to first search for a bootable floppy disk in the floppy drive. If it finds one present, it boots up from that floppy disk. If not, the computer continues to search for a bootable CD-ROM in the CD-ROM drive. If it cannot boot up from the CD-ROM drive, it continues by booting up from the hard disk. To set the boot drive sequence, use the cursor up/down keys to select a priority level (1st, 2nd and 3rd), then use the cursor left/right keys to select the device for that priority level. Onboard Device Configuration The parameters in this screen are for advanced users only. You do not need to change the values in this screen because these values are already optimized. The Onboard Device Configuration screen assigns resources to basic computer communication hardware. Onboard Devices Configuration Serial Port Base Address IRQ Parallel Port Base Address IRQ Operation Mode ECP DMA Channel [Enabled ] [3F8h] [4 ] [Enabled ] [378h] [7] [Bi-directional] [-] Page 1/1 ↑↓ = Move highlight bar, ←→ = Change setting, F1 = Help The following table describes the parameters in this screen. Settings in boldface are the default and suggested parameter settings. Parameter Serial Port Parallel Port Description Options Enables or disables the serial port. When enabled, you can set the base I/O address and interrupt request (IRQ) of the serial port. Enabled or Disabled 3F8h, 2F8h, 3E8h or 2E8h 4 or 3 Enables or disables the parallel port. When enabled, you can set the base I/O address, interrupt request (IRQ) and operation mode of the parallel port. If operation mode is set to ECP, the direct memory access (DMA) channel of the parallel port is set to 1. Enabled or Disabled 378h, 278h, or 3BCh 7 or 5 Bi-directional, EPP, ECP or Standard Chapter 2 33