Acer X3200 EF9100A Aspire X1200 / X3200 Service Guide - Page 26

Integrated Peripherals Parameter IDE Function Setup MCP Storage Config Init Display First HD Audio HDMI Audio MAC LAN IDE HDD Block Mode Onboard Serial Port 1 Onboard Parallel Port Parallel Port Mode ECPM Mode Use DMA USB Device Setting Description Press Enter to access the IDE Function Setup submenu. Press Enter to access the MCP Storage Config submenu. Select whether to boot the system using the AGP graphic card or a PCI card installed on the PCI Express slot or PCI slot. Enables or disables the onboard audio controller. Allows you to control the audio function of the onboard HDMI. Enables or disables the built-in network interface card. When enabled, the BIOS will automatically detect if your hard disk supports block transfers and set the proper block transfer settings for it. Depending on the IDE controller, up to 64 KB of data can be transferred per interrupt when block transfers are enabled. When disabled, only 512 bytes of data can be transferred per interrupt. Select the I/O address and IRQ for the first serial port. Select the I/O address and IRQ for the onboard parallel port. Select an operating mode for the onboard parallel port. Select DMA channel for the LPT port in ECP mode. This parameter can be configured if the parallel port mode is set to ECP or ECP +EPP mode. Press Enter to access the USB Device Setting submenu. Option PCIEx PCI Slot Onboard Auto Disabled Disabled Auto Auto Disabled Enabled Disabled 3F8/IRQ4 2F8/IRQ3 3E8/IRQ4 2E8/IRQ3 Auto Disabled 378/IRQ7 278/IRQ5 3BC/IRQ7 Disabled SPP EPP ECP ECP+EPP 3 1 18 Chapter 2