Adaptec AHA-2742 Installation Guide

3.

Make sure the SCSI hard disk drive SCSI ID is

set to ID 0. The drive SCSI ID is normally set

with jumpers or switches on the drive. Each

SCSI devices should be set to a unique SCSI ID.

4.

Make sure the SCSI termination is set correctly.

(See Section

,

Connecting Peripherals

for

information on SCSI termination.)

5.

A low-level format of the SCSI hard disk may be

necessary. Be sure to backup first, then run the

Format utility accessible through the EISA

Configuration utility.

Multiple Host Adapters

Make sure that each host adapter is set to a sepa-

rate

BIOS address

. Or,

disable

the BIOS on all but

one of the host adapters.

9

Adaptec Customer Support

•

The Adaptec electronic Bulletin Board Service

(BBS) provides information on software

upgrades, new releases, technical advice, and

more. The BBS can be reached 24 hours a day at

408-945-7727; 1200/2400/9600 baud, 8 data bits,

1 stop bit, no parity.

•

The Adaptec Technical Support Hot Line

can be reached at 800-959-SCSI (7274), or

408-945-2550; M-Th: 6:00 a.m. to 5:00 p.m.,

F: 6:00 a.m. to 3:00 p.m. PST.

•

The Adaptec Technical Support FAX can be

reached 24 hours a day at 408-945-6776.

•

Adaptec software can be ordered by calling

800-442-7274; M-F: 5:00 a.m. to 6:00 p.m. PST.

•

Additional documentation for Adaptec products

can be requested by calling 800-934-2766;

M-F: 5:00 a.m. to 6:00 p.m. PST.

10

FCC Compliance Statement

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15

of the FCC rules. These limits are designed to provide reason-

able protection against harmful interference in residential in-

stallations. This equipment generates, uses, and can radiate

radio frequency energy, and if not installed and used in accord-

ance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that

interference will not occur in a particular installation.

If this equipment does cause interference to radio or television

equipment reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna

•

Move the equipment away from the receiver

•

Plug the equipment into an outlet on a circuit different

from that to which the receiver is powered

•

If necessary, the user should consult the dealer or an

experienced radio/television technician for additional

suggestions

CAUTION: Only equipment certified to comply with Class B

(computer input/output devices, terminals, printers, etc.)

should be attached to this equipment, and must have shielded

interface cables.

Finally, any change or modifications to the equipment by the

user not expressly approved by the grantee or manufacturer

could void the user’s authority to operate such equipment.

This device complies with part 15 of the FCC rules. Operation

is subject to the following two conditions: (1) this device may

not cause harmful interference and (2) this device must accept

any interference received, including interference that may

cause undesired operation.

Adaptec, Inc.

691 South Milpitas Boulevard

Milpitas, CA 95035

Copyright

1993, Adaptec, Inc.

All rights reserved. Adaptec and the Adaptec logo are

registered trademarks, and AHA and TwinChannel are

trademarks of Adaptec, Inc.

Printed in Singapore

Stock No.: 510364-00

Rev. A

RQ

1/93

Information subject to change without notice.

5

10

11

AHA-2740/2742

Single-Channel

AHA-2740-T/2742-T

TwinChannel

EISA-to-Fast SCSI Host Adapters

Installation Guide

▲

▲

▲

▲

▲

▲

▲

▲

▲

▲

▲

Adaptec AHA-2742 Installation Guide

Adaptec AHA-2742 - Storage Controller Fast SCSI 10 MBps Manual

Adaptec AHA-2742 manual content summary: