Arlo Home Security System Quick Start Guide - Sensors
Arlo Home Security System Manual
 |
View all Arlo Home Security System manuals
Add to My Manuals
Save this manual to your list of manuals |
Arlo Home Security System manual content summary:
- Arlo Home Security System | Quick Start Guide - Sensors - Page 1
One Sensor to your Home Security System After you install your Keypad Sensor Hub, you can use the Arlo Secure App to add All-in-One Sensors. To install your All-in-One Sensor: 1. Open the Arlo Secure App and tap Add Device or + if you have other devices. 2. Follow the setup instructions for your All - Arlo Home Security System | Quick Start Guide - Sensors - Page 2
and: • How-to videos • Troubleshooting tips • Additional support resources Flat Wall Plate with Short Screw and Anchor Corner Wall Plate with Long Screw and Anchor Note: Your sensor might not need a wall plate, depending on how it will be used. The Arlo Secure App explains this during setup.
-
1 -
2
 |
 |
© Arlo Technologies, Inc. Arlo, Arlo logo, and Every Angle Covered
are trademarks of Arlo Technologies, Inc. Any other trademarks are
for reference purposes.
Si ce produit est vendu au Canada, vous pouvez accéder à ce
document en français canadien à
arlo.com/docs
.
(If this product is sold in Canada, you can access this document in
Canadian French at
arlo.com/docs
.)
For regulatory compliance information including the EU
Declaration of Conformity, visit
www.arlo.com/about/regulatory/
.
Arlo Technologies, Inc.
2200 Faraday Avenue, Suite 150
Carlsbad, CA 92008 USA
Add an All-in-One Sensor to
your Home Security System
August 2022
Aſter you install your Keypad Sensor Hub, you can
use the Arlo Secure App to add All-in-One Sensors.
To install your All-in-One Sensor:
1.
Open the Arlo Secure App and tap
Add Device or
+ if you have other devices
.
2.
Follow the setup instructions for your All-in-One
Sensor.
Note:
The sensor is for indoor use only.
The
Arlo Secure App shows you how to separate
and reattach the front module from the back
housing.
Do not attach the sensor adhesive unless the app
instructs you to do so. If you’re using the sensor
to detect water leaks, the adhesive isn’t needed.
201-50587-03