Audiovox 07SPR Programming Guide

Audiovox 07SPR Manual

Audiovox 07SPR manual content summary:

  • Audiovox 07SPR | Programming Guide - Page 1
    Model 07SPr Transmitter Programming Guide These transmitters makes use of icons (symbols) to identify the reaction your security system/keyless entry/and or remote start system, where applicable, will have when any icon (button) is pressed. These icons are programmed at time of installation to meet
  • Audiovox 07SPR | Programming Guide - Page 2
    transmitter are: AS 9075 Remote car starter AS 9153 Remote window roll up AS 9256 Remote trunk release relay Although the most common use of the transmitter buttons are shown on the front page of this guide, any button or button combination can be programmed into any receiver channel. Additionally
  • Audiovox 07SPR | Programming Guide - Page 3
    advance to channel 2. The siren will chirp 2 times and the dash-mounted LED will Flash 2 times, indicating that the unit is ready to accept programming for channel # 2 which is only used for separate lock and unlock button transmitters, and is the disarm/unlock/unlock 2 and panic. 6) Press and hold
  • Audiovox 07SPR | Programming Guide - Page 4
    . (Repeat this for each transmitter you wish to operate the Channel 6 output, Driver Priority 1) 15) Within 10 seconds, press and release the valet program switch one time. (Siren emits 7 short chirps indicating channel 7 has been entered) 16) Within 10 Seconds, Press and hold the unlock button (or
  • Audiovox 07SPR | Programming Guide - Page 5
    is heard. If a single chirp or multiple chirps, (up to 7 chirps), are heard, the unit is indicating that the transmitter has already been programmed elsewhere in the receiver. Release the transmitter button and within 5 seconds press and hold until a long chirp is heard. This action forces the unit
  • Audiovox 07SPR | Programming Guide - Page 6
    Using the edge of a coin, or a small flat screwdriver blade, carefully remove transmitter back cover keeping hold of the metal key ring to prevent it's loss. Carefully remove the discharged battery by sliding it out from under the clip in the direction indicated by the arrow in the diagram below.
  • Audiovox 07SPR | Programming Guide - Page 7
    07SPr Transmitter Attention: Transmitter Ordering Department Important: To help us expedite your order, please print all of the information legibly and mail this form and your payment according to the instructions and follow the instructions from the operator interface. Audiovox Electronics Corp.,
  • Audiovox 07SPR | Programming Guide - Page 8
    © 2007 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY, 11788 128-8182 8 128-8182 8 of 8
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

128-8182
1 of 8
1
2
1
3
3
*4
*5
BUTTON
RECEIVER
CHANNEL
SYSTEM FUNCTION
Lock And Arm Alarm, also initiate and
terminates *Panic
Unlock And Disarm, also initiates and
terminates
*Panic.
Programmable to
unlock drivers door and or all doors.
Lock and arm/unlock and disarm.
May
be programmed to unlock driver's door
or all doors. Also will initiate and
terminate *Panic.
Pulsed or switched output to control
Remote Trunk Release or optional
device connected to channel 3.
When pressed and release two times,
will provide pulsed output or activate the
Remote Start option when installed.
When so equipped, this button can be
used to operate an optional device
connected to channel 4.
When so equipped, this button can be
used to operate an optional device
connected to channel 5.
These transmitters makes use of icons (symbols) to identify the reac-
tion your security system/keyless entry/and or remote start system,
where applicable, will have when any icon (button) is pressed.
These icons are programmed at time of installation to meet the needs of
the individual and to complement the vehicle that the system is installed
in.
To replace a transmitter or add transmitters, please follow the
programming instructions listed on the pages of this manual.
Transmitter Programming Guide
* Where So Equipped
Model 07SPr