Audiovox RC107 User Manual

user

manual

guide de l’utilisateur

RC107

v4.0 (1.0.4.0) (EN/F)

Before you begin

Clock

EN/F

It is important to read this user manual prior to using your new product for the first time.

Nous vous recommandons de lire ce manuel d’instructions avant d’utiliser votre

nouveau produit pour la première fois.

Plugging in for power

• Connect the supplied power adapter

to the unit’s AC IN jack at the back,

and connect to a convenient wall

outlet.

•

Refer to the “Clock” section and

follow the instructions to set the

clock.

Battery back-up operation

•

This clock radio is equipped with

a timekeeping system that can be

powered with a 9-volt alkaline

battery (not included). The power

failure protection circuit will not

operate unless battery is installed.

• When normal household power

is interrupted, or AC line cord

is unplugged, the batteries will

power the clock radio to keep

track of time and alarm settings

programmed into memory.

• When the battery backup functions,

the digital display will not light,

however, the function of alarm

still occurs during the power

interruption if remaining battery

power is adequate.

• Normal operation will resume after

AC power is restored so you will not

have to reset the time or the alarm.

To install the battery:

1.

Remove battery compartment door

(located at the bottom of the radio)

by applying thumb pressure to the

tab on battery door and then lift

the door out and off the cabinet.

2.

Connect a 9-volt alkaline battery

(not included) to the connector

plug.

3.

Replace the compartment door.

Power failure indicator

When AC power is interrupted

(disconnected) for a short period of

time, both time and alarm settings

will be lost (unless batteries are

installed). After AC power is restored

(reconnected), the Digital Display

will blink to indicate that power was

interrupted and you should re-adjust

the time and alarm settings.

General controls

To set the clock:

1. Slide the

/ WAKE 1 / WAKE 2

/

switch to

to enter the clock

setting mode.

2.

Press

or

to set the time.

•

Press and hold to decrease or

increase the time value quickly.

•

The “:” flashes on the display in

clock setting mode.

3.

Slide the

/ WAKE 1 / WAKE 2 /

switch to

.

•

The clock is in 12 hour

format. The AM indicator

lights to show AM time.

• The clock time blinks

if it is not set or after power

interruption (without back-up

battery installed).

Alkaline (NEDA 1604A/

IEC 6LR61) battery is

recommended. Carbon-zinc

battery may be used but memory

holding time will be substantially

reduced. Memory holding time

for a fresh alkaline battery is

approximately 8 hours (if alarm

is not operated) which should

take care of short, nuisance-type

AC power failures. To preserve

battery life, the unit should remain

plugged into an AC outlet. As the

battery gets older, its voltage drops

and memory may be lost. Be sure

to replace the battery periodically.

Battery should be removed if the

unit will be stored for more than

one month. Leaky battery can

badly damage the clock radio.

FCC Information

IMPORTANT SAFETY INSTRUCTIONS

PLEASE READ AND SAVE THIS FOR FUTURE REFERENCE

Some of the following information may

not apply to your particular product;

however, as with any electronic product,

precautions should be observed during

handling and use.

• Read these instructions.

• Keep these instructions.

• Heed all warnings.

• Follow all instructions.

•

Do not use this apparatus near

water.

• Clean only with dry cloth.

• Do not block any ventilation

openings. Install in accordance with

the manufacturer’s instructions.

•

Do not install near any heat sources

such as radiators, heat registers,

stoves, or other apparatus (including

amplifiers) that produce heat.

•

Do not defeat the safety purpose

of the polarized or grounding-type

plug. A polarized plug has two

blades with one wider than the

other. A grounding type plug has

two blades and a third grounding

prong. The wide blade or the third

prong is provided for your safety. If

the provided plug does not fit into

your outlet, consult an electrician

for replacement of the obsolete

outlet.

•

Protect the power cord from being

walked on or pinched particularly at

plugs, convenience receptacles, and

the point where they exit from the

apparatus.

• Only use attachments/accessories

specified by the manufacturer.

• Use only with

the cart, stand,

tripod, bracket,

or table

specified by the

manufacturer,

or sold with

the apparatus.

When a cart is used, use caution

when moving the cart/apparatus

combination to avoid injury from

tip-over.

• Unplug this apparatus during

lightning storms or when unused

for long periods of time.

• Refer all servicing to qualified

service personnel. Servicing is

required when the apparatus has

been damaged in any way, such

as power-supply cord or plug is

damaged, liquid has been spilled

or objects have fallen into the

apparatus, the apparatus has been

exposed to rain or moisture, does

not operate normally, or has been

dropped.

ADDITIONAL SAFETY INFORMATION

• The AC/AC adapter supplied with

this product is intended to be

correctly oriented in a vertical or

floor mount position.

• Do not use unauthorized chargers

or power adapters. Use only

chargers or power adapters that

came with your product or that is

listed in the user’s guide.

•

Apparatus shall not be exposed to

dripping or splashing and no objects

filled with liquids, such as vases,

shall be placed on the apparatus.

•

Always leave sufficient space around

the product for ventilation. Do

not place product in or on a bed,

rug, in a bookcase or cabinet that

may prevent air flow through vent

openings.

•

Do not place lighted candles,

cigarettes, cigars, etc. on the

product.

•

Care should be taken so that objects

do not fall into the product.

•

Do not attempt to disassemble

the cabinet. This product does

not contain customer serviceable

components.

• The marking information is located

at the bottom of apparatus.

• To be completely disconnect the

power input, the AC/AC adapter

of apparatus shall be disconnected

from the mains.

• AC/AC adapter is a disconnect

device. The AC/AC adapter should

not be obstructed OR should be

easily accessed during intended use.

• The ventilation should not be

impeded by covering the ventilation

openings with items such as

newspaper, table-cloths, curtains etc.

•

No naked flame sources, such as

lighted candled, should be placed

on the apparatus.

•

Attention should be drawn to the

environmental aspects of battery

disposal.

•

The use of apparatus in moderate

climates.

Important battery

precautions

•

Any battery may present a risk of

fire, explosion, or chemical burn

if abused. Do not try to charge a

battery that is not intended to be

recharged, do not incinerate, and

do not puncture.

• Non-rechargeable batteries, such as

alkaline batteries, may leak if left in

your product for a long period of

time. Remove the batteries from the

product if you are not going to use

it for a month or more.

•

If your product uses more than one

battery, do not mix types and make

sure they are inserted correctly.

Mixing types or inserting incorrectly

may cause them to leak.

• Discard any leaky or deformed

battery immediately. They may

cause skin burns or other personal

injury.

• Please help to protect the

environment by recycling or

disposing of batteries according to

federal, state, and local regulations.

WARNING: The battery (battery or

batteries or battery pack) shall not

be exposed to excessive heat such as

sunshine, fire or the like.

Ecology

Help protect the environment - we

recommend that you dispose of used

batteries by putting them into specially

designed receptacles.

Note:

This equipment has been tested

and found to comply with the limits

for a Class B digital device, pursuant

to Part 15 of FCC Rules. These limits

are designed to provide reasonable

protection against harmful interference

in a residential installation. This

equipment generates, uses, and can

radiate radio frequency energy and, if

not installed and used in accordance

with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee

that interference will not occur in a

particular installation. If this equipment

does cause harmful interference to

radio or television reception, which

can be determined by turning the

equipment off and on, the user is

encouraged to try to correct the

interference by one or more of the

following measures:

•

Reorient or relocate the receiving

antenna.

•

Increase the separation between the

equipment and receiver.

•

Connect the equipment into an

outlet on a circuit different from

that to which the receiver is

connected.

•

Consult the dealer or an

experienced radio/TV technician for

help.

Changes or modifications not expressly

approved by Audiovox could void

the user’s authority to operate the

equipment.

]

Portable Cart Warning

This Class B digital apparatus

complies with Canadian ICES-003.

Cet appareil numérique de la classe

B est conforme à la norme NMB-003

du Canada.

Electrical power

information

AC/AC adapter power supply:

120 V ~ 60 Hz

AC output: 10.5V @ 1 A

Right view

Left view

• – VOLUME +

– To adjust volume

• TUNING

– To adjust radio frequency

• USB Charging

– To charge your cell

phones via this USB connector

Top view

• ON/OFF

– To turn radio on or off;

cancel the wake function.

•

/ WAKE 1 / WAKE 2 /

– To

select setting mode (

: lock

mode,

WAKE 1 / WAKE 2

:

wake

setting mode,

: clock setting

mode)

• SNOOZE/SLEEP OFF

– To quiet

the wake alarm or wake radio

temporarily (default: 9 minutes);

cancel the sleep function

•

– To decrease value when setting

clock, wake, snooze and sleep

modes.

•

–

To increase value when setting

clock, wake, snooze and sleep

modes.

• WAKE 1

MODE

– To activate the

Wake 1 settings; change wake 1

mode (radio/alarm).

• WAKE 2

MODE

– To activate the

Wake 2 settings; change wake 2

mode (radio/alarm).

• SLEEP

– To activate the sleep

function

• AM/FM

– To select radio band

• AM – AM time

•

1 – Wake time 1 to alarm

•

1 – Wake time 1 to radio

•

2 – Wake time 2 to alarm

•

2 – Wake time 2 to radio

Display

Indicator

Audiovox RC107 User Manual

Audiovox RC107 Manual

Audiovox RC107 manual content summary: