Audiovox TV-44 Owners Manual
Audiovox TV-44 Manual
 |
View all Audiovox TV-44 manuals
Add to My Manuals
Save this manual to your list of manuals |
Audiovox TV-44 manual content summary:
- Audiovox TV-44 | Owners Manual - Page 1
TV42 Owner's Manual Amplified/Outdoor Satellite Dish Clip-on Antenna - Audiovox TV-44 | Owners Manual - Page 2
close to overhead wires such as power lines, telephone lines or cable TV lines. If any part of the antenna makes contact with overhead power lines, touching the antenna or the antenna cable can cause electrocution and death. If the antenna is in contact with any type of overhead wires, call your - Audiovox TV-44 | Owners Manual - Page 3
missing any pieces, please call TERK Technical Support at 1(800) 942-TERK (8325). How to install your new TV42 antenna The TV42 installation consists of TV42 Antenna (2) 32" Coaxial Cables TV/SAT INSIDE DIPLEXER TV SAT TV/SAT INSIDE DIPLEXER TV SAT (2) Indoor Diplexers (2) Security Clips - Audiovox TV-44 | Owners Manual - Page 4
satellite dish 1. Make sure all satellite receivers are turned off and unplugged from the electrical outlet. 2. Unsnap the antenna from the back notch of the mounting clamp. See Fig 2. Fig 2 3. Hold the antenna to the back of the dish so that the circular housing is centered with the FTig 2ERK logo - Audiovox TV-44 | Owners Manual - Page 5
edge of the dish one at a time. See Fig 4. Fig 4 5. Snap the antenna back into the back notch of the mounting Fig 4 clamp. 6. Tighten the clamps by turning the thumb-wheel screw clockwise. Note: We recommend the use of the enclosed security clips for any dish 20" or larger. Snap the security - Audiovox TV-44 | Owners Manual - Page 6
TV42 Depending on the type of satellite dish you have, go to one of the following five scenarios to determine how to connect the TV42 antenna to your satellite dish. A-Single LNB (Phase1) Satellite Dish 1. Remove the LNB from the arm of the satellite dish to expose the satellite cables. See - Audiovox TV-44 | Owners Manual - Page 7
and connect to the LNB. See Fig 8. 5. Reconnect the LNB to the dish arm. See Fig 8. Fig 8. 6. Connect the remaining end of the 2 black 32" antenna cables to the IN 1 and IN 2 tFeigr7m, 8inals on the TV42 antenna. See Fig 9. 6 Fig 9. 7. Continue to "Installing the Indoor Diplexers." - Audiovox TV-44 | Owners Manual - Page 8
to your satellite dish with the TV42. If you would like to use or eventually use up to 4 receivers, you will need to purchase the Terk TV44 antenna instead. 1. Remove the LNB from the arm of the satellite dish to expose the satellite cables. See Fig 10. Fig 10. 2. Disconnect 2 satellite cable - Audiovox TV-44 | Owners Manual - Page 9
the LNB. See Fig 12. 5. Reconnect the LNB to the dish arm. See Fig 12. Fig 12. 6. Connect the remaining end of the 2 black 32" antenna cables to the IN 1 and IN 2 terminals on the TV42 antenna. See Fig 13. 8 Fig 13. 7. Continue to "Installing the Indoor Diplexers." - Audiovox TV-44 | Owners Manual - Page 10
" or "TO RECEIVER" terminals on your multiswitch. 2. Connect the satellite cables to the OUT 1 and OUT 2 terminals on the TV42 antenna. See Fig 14. Fig 14. 3. Using the 2 black 32" antenna cables, connect the IN 1 and IN 2 terminals of the TV42 to the "OUTPUT" or "TO RECEIVER" terminals on your - Audiovox TV-44 | Owners Manual - Page 11
to purchase additional diplexers and antenna wires to complete this installation. 1. Complete "Scenario A" instructions. (Page 5) 2. Locate antenna cables to connect the "TV" terminal of the diplexer to the ANTENNA INPUT on the multiswitch. See Fig 16. 5. Use the other supplied white 12" antenna - Audiovox TV-44 | Owners Manual - Page 12
: You may need to extend the satellite leads using a barrel connector and extra RG6 coaxial cable if they are not long enough. 3. Using 2 black 32" antenna cables connect the "TO RECIEVER" terminals on the SW21 multiswitches to the IN 1 and IN 2 terminals on the TV42 - Audiovox TV-44 | Owners Manual - Page 13
IN" terminal on your satellite receiver. See Fig 18 . Satellite Receiver Fig 18. From Satellite Dish 2. Connect the satellite cable to the terminal marked "TV/SAT" on the indoor diplexer. See Fig 19. 3. Connect one of the supplied white 12" connector cables from the terminal labeled "SAT" on the - Audiovox TV-44 | Owners Manual - Page 14
TV manual for the exact steps to change this option. 3. Set your TV to your favorite channel. 4. To fine tune local channel reception, rotate the TV42 antenna product will be repaired or replaced, at TERK's option, without charge. Please read your instructions thoroughly and use this product only as
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
 |
 |
TV42
Owner’s Manual
Amplified/Outdoor
Satellite Dish Clip-on Antenna