Biostar M7VIG PRO M7VIG Pro BIOS setup guide

Biostar M7VIG PRO Manual

Get Biostar M7VIG PRO PDF manuals and user guides View all Biostar M7VIG PRO manuals
Add to My Manuals
Save this manual to your list of manuals

Biostar M7VIG PRO manual content summary:

  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 1
    M7VIG Pro BIOS Setup BIOS Setup 1 1 Main Menu 3 2 Standard CMOS Features 6 3 Advanced BIOS Features 9 4 Advanced Chipset Features 12 5 Integrated Peripherals 16 6 Power Management Setup 21 7 PnP/PCI Configurations 25 8 PC Health Status 28 9 Frequency Control 29 i
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 2
    M7VIG Pro BIOS Setup BIOS Setup Introduction This manual discussed Award™ Setup program built into the ROM BIOS. The Setup program allows users to modify the basic system configuration. This special information is then stored in battery-backed RAM so that it retains the Setup information when the
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 3
    M7VIG Pro BIOS Setup PCI Bus Support This AWARD BIOS also supports Version 2.1 of the Intel PCI (Peripheral Component Interconnect) local bus specification. DRAM Support DDR (Double Data Rate Synchronous DRAM) are supported. Supported CPUs This AWARD BIOS supports the AMD Socket CPU. Using Setup In
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 4
    M7VIG Pro BIOS Setup 1 Main Menu Once you enter Award BIOS™ CMOS Setup Utility, the Main Menu will appear WARNING !! The information about BIOS defaults on manual (Figure 1,2,3,4,5,6,7,8,9) is just for reference, please refer to the BIOS installed on board, for update information. ! Figure 1. Main
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 5
    M7VIG Pro BIOS Setup Advanced Chipset Features This submenu allows you to configure special change the voltage and clock may cause CPU or M/B damage!) Load Optimized Defaults This selection allows you to reload the BIOS when the system is having problems particularly with the boot sequence. These
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 6
    M7VIG Pro BIOS Setup Set User Password If the Supervisor Password is not set, then but will not be able to change them. Save & Exit Setup Save all configuration changes to CMOS(memory) and exit setup. Confirmation message will be displayed before proceeding. Exit Without Saving Abandon all changes
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 7
    M7VIG Pro BIOS Setup 2 Standard CMOS Features The items in Standard CMOS Setup Menu are divided into 10 categories. Each category includes no, one or more than one
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 8
    M7VIG Pro BIOS Setup Main Menu Selections This table shows the selections that you can make on the Main Menu. Item Options 2M, 5.25 in 720K, 3.5 in Select the type of floppy disk drive installed in your system. 1.44M, 3.5 in 2.88M, 3.5 in None Video EGA/VGA CGA 40 Select the default
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 9
    M7VIG Pro BIOS Setup Item Halt On Base Memory Extended Memory Total Memory Options All Errors No Errors All, but Keyboard All, but Diskette All, but Disk/ Key N/A N/A N/A Description Select the situation in which you want the BIOS to stop the POST process and notify you. Displays the amount of
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 10
    M7VIG Pro BIOS Setup 3 Advanced BIOS Features ! Figure 3. Advanced BIOS Setup Virus Warning This option allows you to choose the Virus Warning feature that is used to protect the IDE Hard Disk boot sector. If this function is enabled and an attempt is made to write to the boot sector, BIOS will
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 11
    M7VIG Pro BIOS Setup tracks. Disabling this option reduces the time it takes to boot-up. The Choices: Disabled (default), Enabled. CPU Internal Cache Depending on the CPU/chipset in use, you may be able to increase memory access time with this option. The Choices: Enabled (default) Enable
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 12
    M7VIG Pro BIOS Setup Typematic For OS The BIOS supports version 1.1 and 1.4 of the Intel multiprocessor specification. Select version supported by the operation memory exceeding 64MB. The Choices: Non-OS2 (default), OS2. Video BIOS Shadow Determines whether video BIOS will be copied to RAM for
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 13
    M7VIG Pro BIOS Setup 4 Advanced Chipset Features This submenu allows you to configure the specific features of the chipset installed on your system. This chipset manage bus speeds and access to system memory resources, such as DRAM. It also coordinates communications with the PCI bus. The default
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 14
    M7VIG Pro BIOS Setup DRAM Timing This item determines DRAM clock/ timing follow SPD or not. The Choices: By SPD (default), Manual. DRAM CAS Latency When DRAM is installed, the number of clock cycles of CAS latency depends on the DRAM timing. The Choices: 2.5 (default), 2. Bank Interleave
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 15
    M7VIG Pro BIOS Setup address space. Host cycles that hit the aperture range are forwarded to the AGP without any translation. The Choices: 64M (default), 256M, 128M, 32M, 16M, 8M, 4M. AGP Mode This item allows you to select the AGP Mode. The Choices: 4X (default), 2X, 1X. AGP Driving Control By
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 16
    M7VIG Pro BIOS Setup PCI1 Post Write When Enabled, CPU writes are allowed to post on the PCI bus. The Choices: Enabled (default), Disabled. PCI2 Post Write When Enabled, CPU writes are allowed to post on the AGP bus. The Choices: Enabled (default), Disabled. PCI Delay Transaction The chipset has an
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 17
    M7VIG Pro BIOS Setup 5 Integrated Peripherals ! Figure 5. Integrated Peripherals OnChip IDE Control The chipset contains a PCI IDE interface with support for two IDE channels. Select "Enabled" to activate the first and / or second IDE interface. If you install a primary and / or secondary add-in IDE
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 18
    M7VIG Pro BIOS driver (Windows 95 OSR2 or a third party IDE bus master driver). If your hard drive and your system software both support Ultra DMA/100, select Auto to enable BIOS support options: VIA-3058 AC97 Audio This option allows you to control the onboard AC97 audio. The Choices: Auto (default
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 19
    M7VIG Pro BIOS Setup Super IO Device If you highlight the literal "Press Enter" options: Onboard FDC Controller Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If install and FDC or the system has no floppy drive, select Disabled
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 20
    M7VIG Pro BIOS Setup Onboard Parallel Port This item allows video cards, this option determines whether the primary display uses a PCI Slot or an AGP Slot. The Choices: PCI Slot (default), AGP. OnChip USB Controller This option should be enabled if your system has a USB installed on the system board
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 21
    M7VIG Pro BIOS Setup Onboard USB Controller This item allows you to enable or disable VT6202 USB 2.0 UHCI and EHCI Controller which provide higher bandwidth (480Mbps) and is backward compatible with USB 1.1. The Choices: Enabled (Default), Disabled. USB Keyboard Support Enables support for USB
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 22
    M7VIG Pro BIOS Setup 6 Power Management Setup The Power Management Setup Menu allows you the ACPI operating system. The Choices: S1 (POS) (default) Power on Suspend S3 (STR) Suspend to RAM Power Management This category allows you to select the type (or degree) of power saving and is directly
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 23
    M7VIG Pro BIOS Setup Min. Power Saving Minimum power management. Suspend Mode = 1 hr. HDD Power Down = 15 min Max. Power Saving Maximum power management only available for sl CPU 40 Min, and 1Hour. Video Off Option This field determines when to activate the video off feature for monitor power
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 24
    M7VIG Pro BIOS Setup DPMS Initial display power management signaling. Modem Use IRQ This determines the IRQ, previously without any subsequent manual intervention. There are 3 sources that provide current to the CMOS area that retains these Power-On instructions; the motherboard battery (3V), the
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 25
    M7VIG Pro BIOS Setup Wake Up on LAN/Ring An input signal on the serial Ring Indicator (RI) line (in Choices: On (default), Off. PCI Master When set to On, you need a LAN add-on card which supports the power function. It should also support the wake-up on LAN jump. The Choices: Off (default), On. 24
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 26
    M7VIG Pro BIOS Setup 7 PnP/PCI Configurations This section describes configuring the PCI bus system. PCI, or Personal Computer Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed of the CPU itself uses when communicating with its own special components. This
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 27
    M7VIG Pro BIOS Setup are reserved in the system BIOS. If the Disabled (default) option is chosen, the system's ESCD will update only when the new configuration varies from the last one. If the Enabled option is chosen, the system is forced to update By" is set to "Manual". IRQ-3 IRQ-4 IRQ-5
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 28
    M7VIG Pro BIOS Setup graphic controller is on an ISA bus, the Write Access to the palette will not show up on the ISA bus if the PCI
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 29
    M7VIG Pro BIOS Setup 8 PC Health Status ! Figure 8. PC Health Status Current CPU Temperature This field displays the current temperature of the CPU. Current CPUFAN Speed This field displays the current speed of CPU fan. Current SYSFAN Speed This field displays the current speed SYSTEM fan. CPU
  • Biostar M7VIG PRO | M7VIG Pro BIOS setup guide - Page 30
    M7VIG Pro BIOS Setup 9 Frequency Control ! Figure 9. Frequency Control Auto Detect DIMM/ PCI Clk Choices: +/-0.25% (default), Disabled, -0.5%, +/-0.5%, +/-0.75%. CPU Host/ PCI Clock This item allows you to select CPU Clock, and CPU over clocking. If unfortunately, the system's frequency that you are
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
M7VIG Pro BIOS Setup
i
BIOS Setup
.......................................................................................
1
1 Main Menu
...................................................................................................
3
2 Standard CMOS Features
.............................................................................
6
3 Advanced BIOS Features
.............................................................................
9
4 Advanced Chipset Features
........................................................................
12
5 Integrated Peripherals
.................................................................................
16
6 Power Management Setup
..........................................................................
21
7 PnP/PCI Configurations
..............................................................................
25
8 PC Health Status
.........................................................................................
28
9 Frequency Control
......................................................................................
29