Bosch B36FD50SNB Supplemental 2

8001193698

(0004)

en-us, fr-ca

1.

Remove information material,

adhesive tape and protective foil.

2.

Remove the power cord and

the equipment package from the

appliance.

3.

Clean the appliance.

4.

Roll appliance to its final location.

1.

Press

menu

button.

2.

Press

light settings

button.

3.

Press

Y

/

X

Settings button

repeatedly until the settings

display shows the desired

brightness level.

1.

Fit the handles vertically and

horizontally onto the

pre-assembled bolts.

2.

Use the included 2.5 mm

Allen wrench to tighten the

pre-assembled screws

clockwise in the handles.

First steps

Quickstart

Helpful Hints

Cleaning your appliance

Lighting customization

Installing the handles

Align the vertical gap

between the doors

Align the horizontal gap

between the doors

Installing the equipment

Water and electrical

connection

Purge the water system

Aligning the appliance

Note:

Note:

WARNING:

Note:

Note:

The holes in the door handles face

up and down (vertical handles) and

the holes in the drawer handles only

face down (horizontal handles).

Never use stainless steel

cleaners on the exterior of

the appliance.

Never reach into the dispenser

opening of the ice cube bin.

RISK OF INJURY!

0

= lighting oﬀ

1

= minimum brightness

5

= maximum brightness

For important safety instructions, information on installation, use and

maintenance of the appliance, please refer to the entire user manual.

1.

Using a wrench, screw down both

height adjustable feet, so that

they firmly touch the floor.

2.

Adjust each separately, so that

the appliance is also aligned and

straight.

3.

Use a level to confirm.

±

Install the loose equipment parts

as shown in the appliance

overview picture.

±

Clean the appliance with a

soft cloth, lukewarm water

and a little pH-neutral

cleaning liquid.

±

Mainly fruit as well as for a

large load – set lower air

humidity.

±

Mainly vegetables as well as

for a mixed or small load –

set higher air humidity.

1.

Press

bottle fill

button.

2.

Place a pitcher or bottle under

the water dispenser opening.

3.

Press

bottle fill

button again.

The pre-defined amount of

water is dispensed.

±

Connect water supply on the rear

of the appliance.

±

Insert the power cord plug on the

rear of the appliance and into an

outlet.

1.

Press the

water

button.

2.

Dispense water for 5 minutes

(approximately 3 gallons) and

discard.

→

refer to "Getting to know your

appliance" in the user manual,

page 14

→

refer to "Installing the appliance"

in the user manual, page 8

→

refer to "Installing the appliance"

in the user manual, page 9

1

2

3

4

5

6

7

8

E

D

bottle

Dispensing ice and water

A

1.

Press

cubed

button,

crushed

button or

water

button.

2.

Keep pressing a glass against

the dispenser lever until the

glass contains the required

amount of ice or water.

Vegetable bin

Bottle filling

C

B

3.

Discard the ice produced within

the first 24 hours.

The humidity in the vegetable bin

can be set according to the type

and quantity of products stored:

bottle

bottle

Note:

Note:

To interrupt dispensing, press

any button of the ice and water

dispenser.

Hold the glass directly under

the dispenser opening to pre-

vent ice and water splashing.

1.

Download the

Home Connect (America)

app.

2.

Scan the

QR code

and follow

the instructions in the app.

Connect your appliance

F

Bosch B36FD50SNB Supplemental 2

Bosch B36FD50SNB Manual

Bosch B36FD50SNB manual content summary: