Bosch HDI8054U Supplement

Bosch HDI8054U Manual

Bosch HDI8054U manual content summary:

  • Bosch HDI8054U | Supplement - Page 1
    off the outside propane tank gas valve to the range. 3. Remove range power cord from electrical outlet or turn breaker instructions in the LP Gas Conversion Installation manual provided with your appiance. Use the following section for the dual valve only (the dual valve is found only on some models
  • Bosch HDI8054U | Supplement - Page 2
    pour connaître le procédé adéquat de conversion de ce brûleur au gaz propane liquide. Toujours lire et suivre toutes les instructions données dans la Notice d'installation et le Manuel d'utilisation et d'entretien de vos appareils. Assurez-vous de lire et de respecter tous les avis de sécurité et
  • 1
  • 2

IMPORTANT UPDATE
LP Gas Conversion - Dual Valve (some models)
Some gas cooktops/rangetops have a dual burner in the center. The LP Gas conversion process varies slightly
for these units due to the dual valve used with them. If your unit has a dual burner in the center please reference
the instructions below for the proper procedure to convert that burner for LP Gas.
Always read and follow all directions found in your appliances Installation Instructions and Use & Care manual.
Be sure to read and observe all safety notices and warnings.
Preparation
CAUTION:
Turn off Gas and Electricity
Before proceeding with the conversion; shut off the gas
supply to the appliance prior to disconnecting the electrical
power.
1.
Turn all control knobs to the "OFF" position.
2.
Shut off the outside propane tank gas valve to the
range.
3.
Remove range power cord from electrical outlet or turn
breaker off at breaker box.
General Information
Read and follow the instructions in the LP Gas Conversion
Installation manual provided with your appiance. Use the
following
section for the dual valve only (the dual valve is
found only on some models with a dual center burner).
Convert Dual Valves for Propane Use
1.
Verify that the dual burner control knob is in the OFF
position.
2.
Remove the knob (pull straight out).
3.
Locate the bypass screw (see illustration below).
Single valve stems are hollow, the bypass screw is
located down in the stem (A). Dual valves have a brass
adjustment screw (B) on the valve housing.
4.
For single valves, insert 1/8” (or smaller) flat head
screwdriver into shaft and turn bypass screw clockwise
until it stops (bypass screw is inside shaft).
DO NOT
OVERTIGHTEN
For dual valves, locate the brass screw near the valve
stem. For cooktops, the bypass screw is located above
and to the right of the valve stem; for ranges, the
bypass screw is located below and to the left of the
valve stem.
Turn bypass screw clockwise until it stops.
DO NOT
OVERTIGHTEN
5.
Replace the knob.
Continue with the instructions in the LP Gas Conversion
manual that came with your appliance.
9000986737 • Rev A • 5V0TMM