Bosch HMV9305 Installation Instructions

Bosch HMV9305 - 1.8 cu. ft. Microwave Manual

Get Bosch HMV9305 - 1.8 cu. ft. Microwave PDF manuals and user guides
UPC - 825225830306
View all Bosch HMV9305 manuals
Add to My Manuals
Save this manual to your list of manuals

Bosch HMV9305 manual content summary:

  • Bosch HMV9305 | Installation Instructions - Page 1
    Over-the-Range Microwave Installation Instructions For Models: HMV9302, HMV9305, HMV9306, HMV9307 PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING IMPORTANT: Save these instructions for the local electrical inspector's use. INSTALLER: Please leave these Installation Instructions with this unit for
  • Bosch HMV9305 | Installation Instructions - Page 2
    Proper installation is the installer's responsibility! - Read the entire manual before you begin. The Model number label is located on the oven front. See Figure 1. Mounting plate is located on back side of microwave oven. See Figure 2. BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS: Model Number
  • Bosch HMV9305 | Installation Instructions - Page 3
    plug. • Place the plug into a properly installed and grounded outlet. See Figure 3. • Do REPAIR THE OVEN YOURSELF! It should be adjusted and repaired by a qualified technician who can check for microwave leakage after repairing the oven. WARNING If you do not use the microwave oven as instructed
  • Bosch HMV9305 | Installation Instructions - Page 4
    opening width 30" min. clearance from bottom of cabinet to cooking surface or countertop (Use templates included with installation instructions) Figure 4 CAUTION • Before you begin installing the oven, PLACE A PIECE OF THE CARTON OR OTHER HEAVY MATERIAL (such as a blanket) over the countertop
  • Bosch HMV9305 | Installation Instructions - Page 5
    , TOOLS, MATERIALS THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN: NOTE: Depending on your ventilation requirements, you may not use all of these parts. Damper/duct connector (for roof vented or wall vented installation) Not Actual Size One power cord clamp and One dark-colored mounting screw
  • Bosch HMV9305 | Installation Instructions - Page 6
    PARTS, TOOLS, MATERIALS YOU WILL NEED THE FOLLOWING TOOLS AND MATERIALS FOR THE INSTALLATION: Carton or other heavy material for covering the counter top. Clear tape (for taping the templates to the wall) Stud finder or thin nail. Saber saw (for cutting vent holes for roof or wall venting)
  • Bosch HMV9305 | Installation Instructions - Page 7
    4 Detail. NOTE: The outlet should be on a circuit dedicated to the microwave oven 120V, 60Hz., AC only with a 15 or 20A fused electrical supply. IMPORTANT: If you do not have the proper wall outlet, you MUST have one installed by a qualified electrician. 2. You will cut the power-supply-cord hole
  • Bosch HMV9305 | Installation Instructions - Page 8
    Figure 6 cabinet "wall-venting" wall cap room-venting cabinet oven Wall-venting 3 1/4"x10" through-the-wall duct Figure 7 oven Figure 8 REMEMBER AS YOU INSTALL THE VENTING: • Keep the length of the ductwork and the number of elbows to a minimum to ventilate your oven efficiently. See examples
  • Bosch HMV9305 | Installation Instructions - Page 9
    STEP 2: PREPARE THE VENTING SYSYTEM STANDARD FITTINGS NOTE: If the existing duct is round, you must use a rectangular-to-round adapter, with a rectangular 3" extension duct installed between the damper assembly and the adapter to prevent the exhaust damper's sticking. DUCT LENGTH The total length of
  • Bosch HMV9305 | Installation Instructions - Page 10
    THE MOUNTING PLATE: 1. Remove any shipping materials and parts from inside the microwave oven. 2. Cover the countertop or cooktop with a thick the grease filters and the power supply cord. ROOF-VENTED INSTALLATION: This oven is shipped assembled for roof-vented. You will need to install the exhaust
  • Bosch HMV9305 | Installation Instructions - Page 11
    VENTING BLOWER WALL-VENTED INSTALLATION: 1. Remove one blower unit mounting screw and one blower plate screw. Remove the blower plate from cabinet. See Figure 13. 2. Carefully lift the blower unit out of the microwave oven Parts "B" blower unit mounting screw Figure 13 Parts "B" Knockout Parts
  • Bosch HMV9305 | Installation Instructions - Page 12
    Figure 17 blower unit exhaust ports ROOM-VENTED (Recirculating) INSTALLATION: 1. Remove one blower unit mounting screw and one blower plate screw. Remove the blower plate from cabinet. See Figure 19. 2. Carefully lift the blower unit out of the microwave oven. 3. Rotate blower unit 90˚ so the
  • Bosch HMV9305 | Installation Instructions - Page 13
    contractor. CAUTION DO NOT ATTEMPT TO INSTALL THE MICROWAVE OVEN IF YOU CANNOT FIND A WALL STUD range or counter top is at least 30 inches. See Figure 4 on page 4. 4. Center mounting plate on rear wall installation Trim the edges "A" "B" and "C" on the upper cabinet template so that the template
  • Bosch HMV9305 | Installation Instructions - Page 14
    COULD RESULT IN DAMAGE TO THE CORD AND ELECTRIC SHOCK. 4. Cut out the venting areas (with the saber saw): • Roof-Vented: cut out the shaded area marked L on the upper cabinet template. • Wall-Vented: go to STEP 5, INSTALL THE MOUNTING PLATE, located on page 16. 5. Use caulking compound to seal the
  • Bosch HMV9305 | Installation Instructions - Page 15
    installation. Use toggle bolts through these holes unless one of them lines up with a stud. Use a lag screw for studs. NOTE: Draw a fifth circle inside area E, through one of the holes to match the location of a stud. For wall-vented: The oven Line D Support Tab E Figure 26 Support Tab 4.
  • Bosch HMV9305 | Installation Instructions - Page 16
    STEP 5: INSTALL THE MOUNTING PLATE TO THE WALL TO PREPARE THE REAR WALL CUTOUT OPENING AND EXHAUST ADAPTOR/MOUNTING PLATE FOR WALL-VENTED: 1. Place the care to assure the damper hinge is installed so that it is at the top and that the damper swings freely. • Carefully guide the exhaust adaptor (
  • Bosch HMV9305 | Installation Instructions - Page 17
    to lift this microwave. Failure to use more than one person could result in personal injury. 1. Carefully lift microwave oven and hang it on support tabs (See between the upper cabinet and microwave oven is closed. 4. If wall vented or room vented installation is used, go to No.7 on the next
  • Bosch HMV9305 | Installation Instructions - Page 18
    . damper Figure 32 7. To install the grease filter: Slide it into the slide slot, duct then push up and toward oven center to lock. See Figure 34. power supply cord clamp 8. Plug in the power supply cord. Figure 33 9. Read your use and care manual, then check the operation of your microwave
  • Bosch HMV9305 | Installation Instructions - Page 19
    Installation Notes
  • Bosch HMV9305 | Installation Instructions - Page 20
    Printed in Korea P/No.: 3828W5U0310
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
Household Appliances
Over-the-Range Microwave
Installation Instructions
For Models: HMV9302, HMV9305, HMV9306, HMV9307
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING
IMPORTANT: Save these instructions for the local electrical inspector’s use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.