Boss Audio BAB10 User Manual
Boss Audio BAB10 Manual
 |
View all Boss Audio BAB10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Boss Audio BAB10 manual content summary:
- Boss Audio BAB10 | User Manual - Page 1
USER'S MANUAL BAB10 10" (254 mm) LOW PROFILE AMPLIFIED SUBWOOFER iyYM Wv •1 9 351 AUDIO SYSTEMS - Boss Audio BAB10 | User Manual - Page 2
BOSS product. Please read all instructions at low or moderate levels while driving your car. BOSS AUDIO accepts no liability for hearing loss, bodily injury systems. 1. This unit uses BTL (Balanced Transformer less) amplifier circuitry,i.e., floating ground system, serviceable parts inside. -2- - Boss Audio BAB10 | User Manual - Page 3
Circuit Short Protection Circuits Illumination Single Voice Coil loud speaker Signal-to-noise ratio Frequency response Fuse rating Slim Woofer Dimensions(LxWxH)mm BAB10 V 0.2V-6V 3V V 0O-180° 0dB-+6dB 20Hz 50Hz-150Hz 98dB 15Hz-120Hz 15A 10"(2.6 Ohms - Boss Audio BAB10 | User Manual - Page 4
entrusted to a qualified professional. Although these instructions explain how to install AUDIO amplifiers in a general sense, they do not attempt the installation yourself. Instead, please ask your authorized BOSS car audio dealer about professional installation. - Boss Audio BAB10 | User Manual - Page 5
a ring terminal (optional ) for secure connection. 3.If you have any questions regarding the thickness of the power cord,etc., consult your nearest AUDIO dealer. When connecting a unit without a remote lead (a), connect to the accessory circuit of the car which is activated by the ignition switch - Boss Audio BAB10 | User Manual - Page 6
to check for correct balance(red is right and black or white is left). HIGH LEVEL INPUTS Use the high level inputs only if your audio source unit does not have low level outputs. These inputs may be tapped to the closest left and right speaker wires available for greater convenience - Boss Audio BAB10 | User Manual - Page 7
HIGH Le INePRUT Le eR INPUT GAIN 00 MIN MAX O BASS LPF 0 0 0dB 6dB 50H6 150Hz PWR PHASE O O 0 0° PRT =180° FUSE O O O BONS 12V BAB1 0 AUDIO SYSTEMS REM GND O AUTO POWER ON WITH SMART SENSE The AUTO POWER ON feature works only with high level input. Amplifier will detect high input - Boss Audio BAB10 | User Manual - Page 8
Troubleshooting For more details, consult BOSS Authorized Service Center BOSS dealer THE POWER LED DOES NOT LIGHT 1. Check if the fuse the power leads away from the antenna(aerial) lead. DISTORTED AUDIO 1. Check if INPUT LEVEL is set properly. 2. Check if Amplifier of Source unit is defective. -8- - Boss Audio BAB10 | User Manual - Page 9
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
 |
 |
USER'S
MANUAL
BAB10
10"
(254
mm)
LOW
PROFILE
AMPLIFIED
SUBWOOFER
Wv
iyYM
•1
9
351
AUDIO
SYSTEMS