Celestron NexStar 130SLT Computerized Telescope NexStar 130 SLT Quick Setup Gu
Celestron NexStar 130SLT Computerized Telescope Manual
View all Celestron NexStar 130SLT Computerized Telescope manuals
Add to My Manuals
Save this manual to your list of manuals |
Celestron NexStar 130SLT Computerized Telescope manual content summary:
- Celestron NexStar 130SLT Computerized Telescope | NexStar 130 SLT Quick Setup Gu - Page 1
2 Quick Set-up Guide 3 Your NexStar 130SLT includes: optical tube; fork arm; pre-assembled tripod; computerized hand control; hand control holder; two eyepieces; finderscope; accessory tray; documentation including an owner's manual, The Sky® CD and NSOL Telescope Control Software. 4 Assemble - Celestron NexStar 130SLT Computerized Telescope | NexStar 130 SLT Quick Setup Gu - Page 2
Set-up Guide [cont] plastic hand control holder to the tripod leg. 18 Slide Computerized Hand Control into Plug Computerized Hand Control into Before you begin viewing, please the hand align your telescope. Step by step instructions are included in the following Hand Control Setup section. - Celestron NexStar 130SLT Computerized Telescope | NexStar 130 SLT Quick Setup Gu - Page 3
using your NexStar 130SLT, you must setup your computerized hand control and go through the SkyAlign alignment procedure. In order for the NexStar to accurately point to the objects in the sky, it must first be aligned with known positions (stars) in the sky. With this information, the telescope can - Celestron NexStar 130SLT Computerized Telescope | NexStar 130 SLT Quick Setup Gu - Page 4
Hand Control Guide [cont] 13 21 TOUR INFO Repeat the process for the third alignment star. When the telescope has been aligned to the final star, the display will read "Match user's manual. If you have questions or problems with set-up, please contact Celestron Technical Support: 310.803.5955
Extend tripod legs 6 to 8 inches by
loosening the tripod leg locking knob
and pulling the leg to desired length and
re-tightening knob.
Assemble tripod by spreading the legs
out until the center leg brace is fully
extended.
Quick Set-up Guide
1
2
3
All three legs should be the same
length to
provide a level platform for the telescope.
A
bubble level is included (inset) to assist in leveling.
4
7
Hold the telescope fork arm and place
the bottom of the base inside the tripod
mounting platform as shown.
Place accessory tray on top of center leg
brace by lining up the grooves on the
tray to the post on the brace.
5
Once grooves are aligned, turn accessory
tray until it snaps into the clips on each
leg brace.
6
Thread the coupling screw into
the hole at the bottom of the fork arm
base. Tighten screw to secure the
entire fork arm.
8
Slide the optical tube dovetail into the fork
arm
as shown above.
9
NexStar 130SLT
Your NexStar 130SLT includes: optical tube;
fork arm; pre-assembled tripod;
computerized hand control;
hand control
holder;
two eyepieces; finderscope;
accessory tray; documentation including an
owner’s manual, The Sky® CD and NSOL
Telescope Control Software.
Item #31145
Coupling screw