Celestron PowerSeeker 127EQ Telescope PowerSeeker 127 EQ Quick Setup Guide
Celestron PowerSeeker 127EQ Telescope Manual
View all Celestron PowerSeeker 127EQ Telescope manuals
Add to My Manuals
Save this manual to your list of manuals |
Celestron PowerSeeker 127EQ Telescope manual content summary:
- Celestron PowerSeeker 127EQ Telescope | PowerSeeker 127 EQ Quick Setup Guide - Page 1
PowerSeeker 127 Item# 21049 1 Item #31132 2 Questions or Problems with Set-up? CONTACT: Celestron Technical Support: 310.803.5955 For detailed usage information please consult your owner's manual. Quick Set-up Guide 3 Your PowerSeeker 127 includes: optical tube w/ tube rings attached; tripod with - Celestron PowerSeeker 127EQ Telescope | PowerSeeker 127 EQ Quick Setup Guide - Page 2
Quick Set-up Guide [cont] 10 11 12 Locate the counterweight bar and cap from the front of the telescope. To observe, look through the eyepiece as shown above. For additional magnification, you can use the included 3x barlow. Place the barlow in the focuser in place of the eyepiece -
Use the three tightening screws located at the
bottom of each leg to secure the extended legs
in place.
To set up the tripod, spread the legs outward
until they are fully extended. Extend the center
portion of each of the three tripod legs down 6-
8".
Quick Set-up Guide
1
2
3
All three legs should be the same length to
provide a level platform for the telescope.
4
7
Locate the equatorial mount and place the
base of the mount through the hole in the
center of the tripod mounting platform.
5
Properly assembled, the accessory tray should
appear as pictured above.
6
From underneath the tripod mounting platform,
thread the mounting bolt with washer into the
threaded hole on the bottom of the equatorial
mount.
8
Thread the latitude adjustment screw into the
equatorial mount until it is touching the inside
of the mount.
9
PowerSeeker 127
Your PowerSeeker 127 includes:optical tube w/
tube rings attached;tripod with center support
bracket; equatorial mount; two eyepieces; a 3x
barlow lens, finderscope; 5 lb.counterweight;
counterweight bar;two slow motion cables;
eyepiece accessory tray; The Sky™ CD software;
documentation including owner’s manual.
Item# 21049
Place the accessory tray on top of tripod's
center leg brace.Thread the tray into the
threaded hole in the center of the leg brace.
Questions or Problems with Set-up?
CONTACT:
Celestron Technical Support: 310
.
803
.
5955
For detailed usage information please
consult your owner’s manual.