Celestron PowerSeeker 50 Telescope PowerSeeker 50 Quick Setup Guide

Celestron PowerSeeker 50 Telescope Manual

View all Celestron PowerSeeker 50 Telescope manuals Add to My Manuals Save this manual to your list of manuals

• 
  1
• 
  2

Match case Limit results 1 per page

---

100% Actual Size Fit Width Fit Height Fit Page Automatic

Use the three tightening snaps located at the

bottom of each leg to secure the extended legs

in place.

To set up the tripod, spread the legs outward

until they are fully extended. Extend the center

portion of each of the three tripod legs down 6-

8".

Quick Set-up Guide

1

2

3

All three legs should be the same length to

provide a level platform for the telescope.

4

7

Replace threaded bolt to secure the optical

tube to the mount. Attach the nut to the

threaded bolt by turning clockwise and tighten.

Make sure nut falls into recess.

5

Line up hole in mount with the hole on the

underside of the optical tube as shown above.

6

Properly assembled, optical tube should

appear as pictured above.

8

Remove knurled finderscope nuts from the

optical tube.

9

PowerSeeker 50

Your PowerSeeker 50 includes:optical tube w/ lens

shade attached;tripod with center support bracket;

three eyepieces;a 3x barlow lens, star diagonal,

finderscope with bracket; The Sky™ CD software;

documentation including owner’s manual.

Item# 21039

Remove the threaded bolt from the underside

of the telescope tube.

Questions or Problems with Set-up?

CONTACT:

Celestron Technical Support: 310

.

803

.

5955