Cisco 15454-TCC User Guide

Cisco 15454-TCC - Network Processor Card Manual

Get Cisco 15454-TCC - Network Processor Card PDF manuals and user guides
UPC - 746320351209
View all Cisco 15454-TCC manuals
Add to My Manuals
Save this manual to your list of manuals

Cisco 15454-TCC manual content summary:

  • Cisco 15454-TCC | User Guide - Page 1
    of TCC-I card features, installation procedures, removal instructions, and technical specifications. Use this document in conjunction with the Cisco ONS 15454 SDH Installation and Operations Guide and the Cisco ONS 15454 SDH Troubleshooting and Reference Guide when working with TCC-I cards. This
  • Cisco 15454-TCC | User Guide - Page 2
    that the system maintains Stratum 3 E (G.813) timing requirements. Figure 1 shows the TCC-I faceplate and Figure 2 shows a block diagram of the card. Figure 1 TCC-I faceplate TCC-I FAIL ACT/STBY CRIT MAJ MIN REM SYNC ACO ACO ASYNC LAN 61207 Installing ONS 15454 SDH TCC-I Cards 2 78-14610-01
  • Cisco 15454-TCC | User Guide - Page 3
    p l a n e 61208 TCC-I Functionality The TCC-I supports multichannel, high-level data link card failure. The TCC-I performs all system-timing functions for each ONS 15454 SDH. The TCC-I monitors the recovered clocks from each traffic card and two BITS ports for frequency accuracy. The TCC
  • Cisco 15454-TCC | User Guide - Page 4
    accessible on the front panel of the MIC-C/T/P unit. Note Cisco does not support operating the ONS 15454 SDH with only one TCC-I card. For full functionality and to safeguard your system, always operate in a redundant configuration. Note CTC software does not monitor for the presence or absence of
  • Cisco 15454-TCC | User Guide - Page 5
    and audible alarm control are reset. TCC-I Card Specifications • CTC Software - Interface: 10 Base-T cards, when installed in a system, comply with these standards: - Safety: IEC 60950, EN 60950, UL 60950, CSA C22.2 No. 60950, TS 001, AS/NZS 3260 78-14610-01 Installing ONS 15454 SDH TCC-I Cards
  • Cisco 15454-TCC | User Guide - Page 6
    or removing the TCC-I card for the first time. After you become familiar with ONS 15454 SDH card installation and boot caution when servicing. Step 1 Step 2 Step 3 Open the card ejectors. Carefully insert the card into the guide rails of the desired slot (Figure 3 on page 6). The TCC-I card has to
  • Cisco 15454-TCC | User Guide - Page 7
    card turn up. If one or more of the Cisco Transport Controller (CTC) software screen conditions according to "Verify Successful Turn Up of the TCC-I Card" section on page 7 are not met, re-install the card. Replace . Use caution when servicing. 78-14610-01 Installing ONS 15454 SDH TCC-I Cards 7
  • Cisco 15454-TCC | User Guide - Page 8
    3 Log into the CTC software. Right-click the TCC-I card to reveal a pull-down menu. Click Reset Card. (See Figure 4). Figure 4 Resetting from the TCC-I card pull-down menu Step Confirm that the TCC-I card is in standby mode after the reset. Installing ONS 15454 SDH TCC-I Cards 8 78-14610-01
  • Cisco 15454-TCC | User Guide - Page 9
    Related Documentation Related Documentation • DOC-7813038= Cisco ONS 15454 SDH Installation and Operations Guide • DOC-7813037= Cisco ONS 15454 SDH Troubleshooting and Reference Guide 78-14610-01 Installing ONS 15454 SDH TCC-I Cards 9
  • Cisco 15454-TCC | User Guide - Page 10
    using a reader application. The RSS feeds are a free service and Cisco currently supports RSS version 2.0. This document is to be used in conjunction between Cisco and any other company. (0711R) Copyright © 2002, Cisco Systems, Inc. All rights reserved. Installing ONS 15454 SDH TCC-I Cards 10
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
Corporate Headquarters:
Copyright © 2002. Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706
USA
Installing ONS 15454 SDH TCC-I Cards
Product Name: 15454E-TCC-I=
This document contains a description of TCC-I card features, installation procedures, removal
instructions, and technical specifications. Use this document in conjunction with the
Cisco ONS 15454
SDH Installation and Operations Guide
and the
Cisco ONS 15454 SDH Troubleshooting and Reference
Guide
when working with TCC-I cards.
This document contains the following sections:
•
“TCC-I Timing Communication and Control Card Description” section on page 2
•
“TCC-I Card Specifications” section on page 5
•
“Installation Procedures” section on page 6
•
“Removal Procedures” section on page 7
•
“Related Documentation” section on page 9
•
“Obtaining Documentation and Submitting a Service Request” section on page 10
This document contains the following procedures:
“Installation Procedures” procedure on page 6
“Card Turn Up” procedure on page 7
“Verify Successful Turn Up of the TCC-I Card” procedure on page 7
“Removal Procedures” procedure on page 7
“Initiate a Software Reset” procedure on page 8
Note
For information about circuits and card capacities, see the
Cisco ONS 15454 SDH Installation and
Operations Guide.