CyberPower RMCARD400 Release Note
CyberPower RMCARD400 Manual
![]() |
View all CyberPower RMCARD400 manuals
Add to My Manuals
Save this manual to your list of manuals |
CyberPower RMCARD400 manual content summary:
- CyberPower RMCARD400 | Release Note - Page 1
REMOTE MANAGEMENT CARD FIRMWARE RELEASE NOTES Applicable Products: RMCARD400 Version 1.0.2 (Release Date: May 19, 2023) New Features • Added support for future environmental sensors. Feature Improvements • Modifications were done to improve how content is displayed. Fixes • Corrected issue, when
![](/manual_guide/products/cyberpower-rmcard400-release-note-353d3e7/1.png)
RMCARD400 v1.0.2 Release Notes
REMOTE MANAGEMENT CARD FIRMWARE RELEASE NOTES
Applicable Products: RMCARD400
Version 1.0.2 (Release Date: May 19, 2023)
New Features
•
Added support for future environmental sensors.
Feature Improvements
•
Modifications were done to improve how content is displayed.
Fixes
•
Corrected issue, when using the serial port, with not being able to log in to the Command Line
Interface (CLI) after the Manager IP had been set.
•
Fixed an issue with PowerPanel Business not being able to get the UPS model name when
connected to the RMCARD400.
•
Corrected the PDU Type Value from the SNMPv3 trap.
•
Resolves an issue with special characters '--' are not being allowed when setting NTP.
•
Corrects an issue where the RMCARD would unexpectedly send a "Utility power failed" event for
Smart App LCD (OR) series UPS.
•
Fixes an issue where the UPS battery voltage value is displayed incorrectly in PowerPanel
Business (PPB).
•
Corrects NCL Bank 2 information on the Web Interface that was displayed incorrectly with the
following Smart App Online (OL) series UPS: OL8KRTHD, OL10KRTHD, OL12KRTHD, OL8KERTHD,
OL10KERTHD, OL12KERTHD, OL8KRTHDIEC, OL10KRTHDIEC, OL12KRTHDIEC.
•
Resolves an issue with LDAP was not being able to work when the password length was more
than 15 characters.