D-Link DES-1108 Product Manual
D-Link DES-1108 - Switch Manual
 |
UPC - 790069291142
View all D-Link DES-1108 manuals
Add to My Manuals
Save this manual to your list of manuals |
D-Link DES-1108 manual content summary:
- D-Link DES-1108 | Product Manual - Page 1
- D-Link DES-1108 | Product Manual - Page 2
10 Connecting the Switch 10 PC to DES-1108 10 Hub/Switch to DES-1108 10 DES-1108 to Other Devices 10 Port Speed & Duplex Mode 11 Mounting the Switch on the Wall 12 Mounting on a cement wall 12 Mounting on a wood wall 12 Troubleshooting 13 Networking Basics 14 Check your IP address - D-Link DES-1108 | Product Manual - Page 3
Section 1 - Product Overview PPraocdkuacgteOCvoenrtevnietsw • D-Link DES-1108 8-port Switch • Manual and Warranty on CD • Four (4) Rubber Feet • Wall Mount Kit • Power Adapter Setup The setup of the DES-1108 can be performed using the following steps: • The power outlet should be within 1.82 - D-Link DES-1108 | Product Manual - Page 4
one of the most common ways of increasing available bandwidth. If segmented correctly, most network traffic will remain within a single segment, enjoying the full-line speed bandwidth of that segment. D-Link DES-1108 User Manual 4 - D-Link DES-1108 | Product Manual - Page 5
latencies. Routers have also been used to segment local area networks, but the cost of a router, the setup and maintenance required, make routers relatively impractical. Today switches are an ideal solution to most kinds of local area network congestion problems. D-Link DES-1108 User Manual 5 - D-Link DES-1108 | Product Manual - Page 6
port; and it controls the data flow between the transmit and receive nodes to guarantee against possible packet loss. • The DES-1108 is an unmanaged 10/100Mbps Fast Ethernet switch that offers solutions for the accelerating bandwidth needs of small Ethernet workgroups. D-Link DES-1108 User Manual - D-Link DES-1108 | Product Manual - Page 7
. • Flow control for any port. This minimizes dropped packets by sending out collision signals when the port's receiving buffer is full. • Data filtering rate eliminates all error packets, runts, etc., per port at wire-speed for 100Mbps operation and 10Mbps operation. D-Link DES-1108 User Manual 7 - D-Link DES-1108 | Product Manual - Page 8
Front Panel (LEDs) Power: This green indicator light is on when the DES-1108 is receiving power; otherwise, it is off. Link/Activity (1-8): This LED indicator light is green when the port is connected to a 100Mbps Fast Ethernet station. The green indicator blinks as Ethernet data is transmitted or - D-Link DES-1108 | Product Manual - Page 9
it simple to connect to the switch-just plug either a Crossover or Straight-Through CAT5 cable into any port. DC Power Jack: Power is supplied through an external DC power adapter. Check the technical specification section for information about the DC power input voltage. Since the DES-1108 does not - D-Link DES-1108 | Product Manual - Page 10
UTP/STP Straight-Through or Crossover cable. A Category 5 (or higher) cable must be used for 100Mbps operation. The connection can be accomplished from any (MDI-X) port on the DES-1108 to any of the 10Mbps or 100Mbps (MDI-X) ports on another switch or other devices. D-Link DES-1108 User Manual 10 - D-Link DES-1108 | Product Manual - Page 11
-detecting the network speed (10Mbps or 100Mbps) for any new twisted-pair connection. If the attached device does not support auto-negotiation or has auto-negotiation disabled, an auto-sensing process is initiated to select the speed and half-duplex mode is selected. D-Link DES-1108 User Manual 11 - D-Link DES-1108 | Product Manual - Page 12
Hook the mounting holes of the switch back on the screws. Mounting on a wood wall 1. Drive the T3 x 15 L screws into the wood wall. 2. Hook the mounting holes of the switch back on the screws. (1) 3/4 inch minimum for wood wall (2) 3 inch minimum for cement wall. D-Link DES-1108 User Manual 12 - D-Link DES-1108 | Product Manual - Page 13
using my D-Link DES-1108 switch? If you are connecting directly to a Cable or DSL modem, you will need a router to "share" your Internet connection or a computer using ICS (Internet Connection Sharing) or Proxy. Switches and hubs do not allow you to share a single IP address to multiple computers - D-Link DES-1108 | Product Manual - Page 14
the IP address, subnet mask, and the default gateway of your adapter. If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software programs may block a DHCP request on newly installed adapters. D-Link DES-1108 User Manual 14 - D-Link DES-1108 | Product Manual - Page 15
Set Default Gateway the same as the LAN IP address of your router (192.168.0.1). Set Primary DNS the same as the LAN IP address of your router (192.168.0.1).The Secondary DNS is not needed or you may enter a DNS server from your ISP. Step 5 Click OK twice to save your settings. D-Link DES-1108 User - D-Link DES-1108 | Product Manual - Page 16
100Mbps auto-negotiation, auto MDI-X ports DC inputs DC 5V/1.2A Power Consumption 3.9 watts (Max.) Temperature Operating: 0° ~ 50° C (32º to 122º F) Storage: -10° ~ 70° C (14ºto 158º F) Humidity Operating: 10% ~ 90% RH, Non-condensing Storage: 5% ~ 90% RH, Non-condensing D-Link DES-1108 User - D-Link DES-1108 | Product Manual - Page 17
device Filtering Address Table: 1K entries per device Packet Filtering / Forwarding Rate: 10Mbps Ethernet: 14,880/pps100Mbps Fast Ethernet: 148,800/pps MAC Address Learning: Tx + (transmit) 4 Not used 5 Not used 6 Tx - (transmit) 7 Not used 8 Not used D-Link DES-1108 User Manual 17 - D-Link DES-1108 | Product Manual - Page 18
453-5465 24 hours a day, seven days a week. Internet Support: http://support.dlink.com [email protected] For customers within Canada: Phone Support: (800) 361-5265 Monday to Friday 7:30am to 9:00pm EST Internet Support: http://support.dlink.ca email:[email protected] D-Link DES-1108 User Manual 18 - D-Link DES-1108 | Product Manual - Page 19
the defective Hardware will be refunded by D-Link upon return to D-Link of the defective Hardware. All Hardware or part thereof that is replaced by D-Link, or for which the purchase price is refunded, shall become the property of D-Link upon replacement or refund. D-Link DES-1108 User Manual 19 - D-Link DES-1108 | Product Manual - Page 20
if D-Link determines in its sole discretion that it is not practical to replace the non-conforming Software, the price paid . • The customer must obtain a Case ID Number from D-Link Technical Support at 1-877-453-5465, who will attempt to assist the dlink.com/. D-Link DES-1108 User Manual 20 - D-Link DES-1108 | Product Manual - Page 21
power surge, and cosmetic damage; Any hardware, software, firmware or other products or services provided by anyone other than D-Link; and Products that have been purchased from inventory clearance or liquidation sales or other sales in which D-Link NONINFRINGEMENT. D-Link DES-1108 User Manual 21 - D-Link DES-1108 | Product Manual - Page 22
D-Link Corporation/D-Link Systems, Inc., as stipulated by the United States Copyright Act of 1976 and any amendments thereto. Contents are subject to change without prior notice. Copyright ©2005-2006 by D-Link Corporation/D-Link Systems, Inc. All rights reserved. D-Link DES-1108 User Manual 22 - D-Link DES-1108 | Product Manual - Page 23
accordance with the instructions, may cause connected. • Consult the dealer or an experienced radio/TV technician for help. For detailed warranty information applicable to products purchased outside the United States, please contact the corresponding local DLink office. D-Link DES-1108 User Manual - D-Link DES-1108 | Product Manual - Page 24
Appendix E - Registration Registration Product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights. Version 1.0 02/08/2006 D-Link DES-1108 User Manual 24
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
