D-Link DGE-660TD Product Manual
D-Link DGE-660TD Manual
 |
UPC - 790069272455
View all D-Link DGE-660TD manuals
Add to My Manuals
Save this manual to your list of manuals |
D-Link DGE-660TD manual content summary:
- D-Link DGE-660TD | Product Manual - Page 1
- D-Link DGE-660TD | Product Manual - Page 2
of such revisions or changes. Manual Revisions Revision 1.0 1.1 Date May 1, 2006 August 14, 2007 Description DGE-660TD Revision A1/A2 Added Windows Vista™ support Trademarks D-Link and the D-Link logo are trademarks or registered trademarks of D-Link Corporation or its subsidiaries in the - D-Link DGE-660TD | Product Manual - Page 3
6 Finishing the Installation 7 Windows Vista™ Users 7 Windows® XP Users 7 Windows® 2000 Users 7 Verify Installation 8 Configuration 9 Configure your Adapter 9 Troubleshooting 12 Networking Basics 15 About Gigabit Ethernet 15 About Auto-negotiation 15 D-Link DGE-660TD User Manual iii - D-Link DGE-660TD | Product Manual - Page 4
end of the chapter. Installation instructions are provided in sections 2 and 3. The D-Link DGE-660TD Gigabit Cardbus PC Card for notebook PCs is a credit-card sized Gigabit adapter for connecting a notebook PC to an Ethernet, Fast Ethernet, or Gigabit network. The notebook PC must be equipped with - D-Link DGE-660TD | Product Manual - Page 5
Package Contents D-Link DGE-660TD Gigabit. Cardbus Adapter CD-ROM System Requirements Minimum System Requirements Notebook Computer with the following: • Windows® 2000/XP/Vista™ operating system • Pentium 150MHz or Faster • 64MB RAM • 32MB Free Hard Drive Space • One Available CardBus Slot • CD - D-Link DGE-660TD | Product Manual - Page 6
No manual setup switches -- automatically configured by software • Low power consumption Supported driver list: • Microsoft Windows Vista™ • Microsoft Windows® XP • Microsoft Windows® 2000 • Microsoft Network Client for DOS (NDIS 2 driver) • NetWare Client for DOS (ODI driver) D-Link DGE-660TD User - D-Link DGE-660TD | Product Manual - Page 7
is connected to a 1000Mbps Gigabit Ethernet Network and the indicator lights amber when the port is connected to a 100Mbps Fast Ethernet Network. Otherwise, this indicator remains off when the port is connected to a 10Mbps Ethernet Network. D-Link DGE-660TD User Manual Link/Activity This indicator - D-Link DGE-660TD | Product Manual - Page 8
the drivers onto your computer. • After a few moments, the "Install Finish" screen will appear. Click "OK". • Select "Yes," if you are prompted to restart your computer. Restart the computer manually if the prompt does not occur. (Go to Start > Shut down > Restart.) D-Link DGE-660TD User Manual - D-Link DGE-660TD | Product Manual - Page 9
laptop. • Gently insert the front end of the DGE-660TD into the Cardbus slot on your laptop until it is firmly seated. Make sure that the card is face-up, as shown. Do not force the insertion. • Connect an Ethernet Cable (CAT5) from a switch or hub to the DGE-660TD. D-Link DGE-660TD User Manual - D-Link DGE-660TD | Product Manual - Page 10
Windows Vista™ Users Windows Vista™ completes the installation of the DGE-660TD automatically. A "Installing device driver software" will appear in the task bar to indicate that the installation is in progress. Windows® XP Users Windows® XP completes the installation of the DGE-660TD automatically - D-Link DGE-660TD | Product Manual - Page 11
the Hardware tab and then click Device Manager. Windows Vista™: Click on System and Maintenance and then click on Device Manager. Step 3: Scroll down and click the plus (+) sign next to Network Adapters. The D-Link DGE-660TD Gigabit CardBus PC Card will be listed. D-Link DGE-660TD User Manual - D-Link DGE-660TD | Product Manual - Page 12
the IP address, subnet mask, and the default gateway of your adapter. If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software programs may block a DHCP request on newly installed adapters. D-Link DGE-660TD User Manual - D-Link DGE-660TD | Product Manual - Page 13
your D-Link network adapter and select Properties. Step 3 Highlight Internet Protocol (TCP/IP) and click Properties. Step 4 Click Use the following IP address and enter an IP address that is on the same subnet as your network or the LAN IP address on your router. D-Link DGE-660TD User Manual 10 - D-Link DGE-660TD | Product Manual - Page 14
(192.168.0.1). The Secondary DNS is not needed or you may enter a DNS server from your ISP. Step 5 Click OK twice to save your settings. D-Link DGE-660TD User Manual 11 - D-Link DGE-660TD | Product Manual - Page 15
. A message indicating the error will appear. 4. After verifying that the DGE-660TD has been installed correctly, check steps 1 and 2 again. If you continue to encounter a problem, please call D-Link Technical Support for assistance. Troubleshooting the Hardware Installation If you experience any - D-Link DGE-660TD | Product Manual - Page 16
or may have a problem. Double-click the "D-Link DGE-660TD Cardbus PC Card" and read the explanation of the problem. This information will be helpful if you require technical support from D-Link. Verify Cable Connections Check to see that the computer you are troubleshooting is properly connected - D-Link DGE-660TD | Product Manual - Page 17
DGE-660TD Card Follow these steps to Ping a device: Ping is the acronym for Packet Internet Groper (PING), a utility to determine if a specific IP address is accessible. It works by sending a packet to the specified address and waiting for a reply. Ping is primarily used to troubleshoot Internet - D-Link DGE-660TD | Product Manual - Page 18
Gigabit Ethernet retains the traditional Ethernet CSMA/CD (Carrier Sense, Multiple Access, and Collision Detect) protocol, it remains wholly compatible with 100Mbps Ethernet while providing a tenfold increase in network capacity. The DGE-660TD that is supported by both Link DGE-660TD User Manual 15 - D-Link DGE-660TD | Product Manual - Page 19
the DGE-660TD and the supporting device. The line will remain ready without further auto-negotiation action until the link is broken. Auto-negotiation then reoccurs at any time that the link is restored, again making the line ready for optimal data communications. D-Link DGE-660TD User Manual 16 - D-Link DGE-660TD | Product Manual - Page 20
°F) Humidity: • Operating: 10%~90% RH • Storage: 5%~90% RG Driver Support: • Microsoft Windows Vista™ • Microsoft Windows® XP • Microsoft Windows® 2000 Emission: • FCC Class B • CE mark Class B • VCCI-B Visit http://support.dlink.com for newest releases of drivers. D-Link DGE-660TD User Manual 17 - D-Link DGE-660TD | Product Manual - Page 21
asked questions and answers to technical issues. For customers within the United States: Phone Support: (877) 453-5465 Internet Support: http://support.dlink.com For customers within Canada: Phone Support: (800) 361-5265 Internet Support: http://support.dlink.com D-Link DGE-660TD User Manual 18 - D-Link DGE-660TD | Product Manual - Page 22
the defective Hardware will be refunded by D-Link upon return to D-Link of the defective Hardware. All Hardware or part thereof that is replaced by D-Link, or for which the purchase price is refunded, shall become the property of D-Link upon replacement or refund. D-Link DGE-660TD User Manual 19 - D-Link DGE-660TD | Product Manual - Page 23
the actual purchase price paid that is attributable to the Software. Except as otherwise agreed by D-Link in writing, the . • The customer must obtain a Case ID Number from D-Link Technical Support at 1-877-453-5465, who will attempt to assist the customer dlink.com/. D-Link DGE-660TD User Manual 20 - D-Link DGE-660TD | Product Manual - Page 24
outside of the package. Do not include any manuals or accessories in the shipping package. DLink will only replace the defective portion of the recommend that you use only an Authorized D-Link Service Office. Improper or incorrectly performed maintenance or repair . D-Link DGE-660TD User Manual 21 - D-Link DGE-660TD | Product Manual - Page 25
from D-Link Corporation/D-Link Systems, Inc., as stipulated by the United States Copyright Act of 1976 and any amendments thereto. Contents are subject to change without prior notice. Copyright ©2007 by D-Link Corporation/D-Link Systems, Inc. All rights reserved. D-Link DGE-660TD User Manual 22 - D-Link DGE-660TD | Product Manual - Page 26
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that destination. The firmware setting is not accessible by the end user. D-Link DGE-660TD User Manual 23 - D-Link DGE-660TD | Product Manual - Page 27
device has been designed to operate with an antenna having a maximum gain of 2 dB. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms. D-Link DGE-660TD User Manual 24 - D-Link DGE-660TD | Product Manual - Page 28
Registration Product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights. Version 1.1 August 14, 2007 D-Link DGE-660TD User Manual 25
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
