Dacor DMO24 Installation Instruction - Over the Range Microwave Oven/Hood Syst - Page 7

MOUNTING OVEN TO THE WALL Two people are recommended to attach the Microwave Oven/Hood to the Mounting Plate. 1. Thread the power supply cord through the hole made in the bottom of the top cabinet. 2. Install the oven by sliding it onto the arms of the Mounting Plate. Push it all the way to the wall. See Figure 16. 3. Tighten two Mounting Screws (D) located in the oven faceplate. See Figure 16. 4. Insert the top tabs of hood louver into the 3 openings on the cavity faceplate holding louver at a slightly outward tilt. Rotate louver so the top tabs are positoned in the cavity faceplate openings. Push in the bottom of louver to ensure that the three bottom clips snap into the cavity faceplate. Check for proper engagement. See Figure 17. 5. Tighten one screw (A) to the outercase cabinet. See Figure 18. 6. Use the two Top Cabinet Screws 3 and two Flat Washers 4, supplied in the INSTALLATION HARDWARE, to attach the unit to the top cabinet. See Figure 19. 7. (For Vertical Exhaust Only) Attach the Exhaust Damper Assembly 8 to the fan cover on the top of the outercase cabinet by sliding it into the slits in the same direction as the arrow. Use Tapping Screw 4 X12 mm 7 from the INSTALLATION HARDWARE and tighten into place. See Figure 19. 8. Make a bundle of the power supply cord and attach it to the inside of the cabinet using the Power Cord Hanger 5. See Figure 19. (D) (D) Figure 16 Upper Tabs Faceplate Lower Tabs Figure 17 Clearance Figure 19 5 Grommet (for metal cabinet only) 3 4 7 (A ) 8 Figure 18 7