Dacor DTCT466 Combination Configuration

Dacor DTCT466 Manual

Get Dacor DTCT466 PDF manuals and user guides View all Dacor DTCT466 manuals
Add to My Manuals
Save this manual to your list of manuals

Dacor DTCT466 manual content summary:

  • Dacor DTCT466 | Combination Configuration - Page 1
    appliances must be installed in accordance with the accompanying installation instructions. All tolerances: +1/16" (+1.6 mm), -0 unless or RNO[V] series single wall oven Wall oven platform, see wall oven planning guide A Minimum from finished countertop to oven platform 36" (91.4 cm) typical
  • Dacor DTCT466 | Combination Configuration - Page 2
    INSTALLATIONS Drop-In Cooktop/ Single Wall Oven Revised 09/12/14 Page 2/2 PLANNING GUIDE Cooktop/Wall Oven Model No. A Min. B C Min. D Min. E of chassis and back of cabinet required, below counter-top. See RNCT Planning Guide. SGM series cooktop with DTO[V] wall oven 30 7/8" (78.4 cm) 19
  • 1
  • 2
All specifications subject to change without notice.
Phone: (800) 793-0093
www.dacor.com
PLANNING
GUIDE
COMBINATION INSTALLATIONS
Drop-In Cooktop/
Single Wall Oven
Document # PGCI-019
Revised 09/12/14
Page 1/2
All tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated
NOTE:
When installing a gas cooktop, the width of the cooktop
must be equal to or wider than the wall oven width.
NOTE:
See following page for dimension key and notes.
PRELIMINARY
WARNING
•
Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
•
All appliances must be installed in accordance with the
accompanying installation instructions.
Dacor DTO[V], DYO[V] or RNO[V]
series single wall oven
36"
(91.4 cm)
typical
counter height
A
Minimum from
finished
countertop to
oven platform
Non-combustible material
Combustible material,
non-combustible material
recommended
E
D
C
Wall oven
platform,
see wall oven
planning guide
24" (61.0 cm)
Minimum interior cabinet depth
B
Cutout depth
Cabinet face
Cabinet face
*
Front of countertop
Drop-in cooktop, approved models:
DCT, ETT, MET, RGC, RNCT
or SGM series only
*DYO series only: 1" (2.5 cm) min.
All tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated
CUTAWAY SIDE VIEW