Dacor EGR30 Installation Instruciton - Backguard

Part No. 65196

Rev. A

Web Site:

www.dacor.com

For a Dealer/Service:

(800) 772-7778

Corporate Phone:

(800) 793-0093

Verify the Package Contents

• Installation Instructions

• Screws

• Backguard Assembly

• Flue Extension Assembly (9” and 24” Models Only)

Your DACOR range was equipped with a shipping cover to protect the internal components prior to installation.

This cover must be removed and replaced by a DACOR backguard for your range to function properly.

WARNING:

Be sure that the unit is not connected to gas or power before proceeding.

1.

Unpack the contents of the box and verify parts.

2.

Remove the single screw on the top of the shipping cover. (Refer to Figure 1)

3.

Slide the shipping cover off the unit. (Refer to Figure 2)

4.

Locate and install the flue exhaust extensions at the rear of the range (9" and 24" backguards only). Use the pro-

vided hex screws and tighten securely into the pre-drilled holes. (Refer to Figures 3 and 4 for the 9” flue exhaust

Installation Instructions

Epicure™ 36/48 Range Backguards

Remove Screw

Shipping Cover

Figure 1: Shipping Cover

Figure 2: Shipping Cover Removal

(36” range shown)

Figure 3: ERD/ERG36 with 9” Flue Extension

Figure 4: ERD48 with 9” Flue Extension