Dacor ERV36 Installation Instructions
Dacor ERV36 Manual
 |
View all Dacor ERV36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dacor ERV36 manual content summary:
- Dacor ERV36 | Installation Instructions - Page 1
Installation Instructions Downdraft Raised Vent Models: ERV36-ER, ERV48-ER Part No. 103106 Rev. H Use these downdraft raised vents only with approved Dacor ® appliances. See the installation instructions for the particular appliance model being installed to determine suitability. - Dacor ERV36 | Installation Instructions - Page 2
www.Dacor.com Dacor Distinctive Service (repairs under warranty only) Phone: (877) 337-3226 (U.S.A. and Canada) Monday - Friday 6:00 a.m to 4:00 p.m. Pacific Time The product data label also specifies the power supply requirements. Model Identification: ERV36-ER = 36-inch wide raised vent ERV48-ER - Dacor ERV36 | Installation Instructions - Page 3
and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. • Always contact the Dacor Customer Service Team about problems and conditions that you - Dacor ERV36 | Installation Instructions - Page 4
installation instructions the Dacor range installation instructions and the remote or in-line blower installation instructions. Improper installation, adjustment, alteration, service or maintenance can cause serious personal injury or property damage. • Before installing or servicing the raised vent - Dacor ERV36 | Installation Instructions - Page 5
Product Specifications Product Dimensions 5/16" (8 mm) thick stiffener across back 2 1/2" (64 mm) 1/4" (6 mm) 2 13/16" (71 mm) Top cap with vent down 1 15/16" (49 mm) 2 9/16" (65 mm) Vent shown in raised position 10" (254 mm) Model Number ERV36-ER ERV48-ER Top Cap Width (A) 36" (914 mm) 48" - Dacor ERV36 | Installation Instructions - Page 6
the power plug can be disconnected for service without removing the raised vent or the range from the cabinet. Planning the Installation General System Layout The vent system consists of the raised vent itself and a single Dacor approved remote or in-line blower (see page 6). warning • Failure to - Dacor ERV36 | Installation Instructions - Page 7
details. • Refer to the range installation instructions for the minimum cutout dimensions specific to the particular range and ERV model being installed. • Install the raised vent and range so that they can be removed if service is required. • The raised vent is equipped with adjustable anchor legs - Dacor ERV36 | Installation Instructions - Page 8
See the blower installation instructions for directions. Only transition to make the connection. one blower shall be installed. • For side and bottom exhaust connections, use the sup- APPROVED DACOR BLOWERS FOR USE WITH MODEL ERV36-ER AND ERV48-ER RAISED VENTS Model Number REMP3 REMP16 - Dacor ERV36 | Installation Instructions - Page 9
Installation Specifications • On side exhaust installations vent system depends on the model of remote or in-line blower used with the vent listed at the right from the Blower Maximum Duct Straight Length. For example, for a raised vent + 4 feet + 2 feet = 36 feet. • The maximum amount of straight - Dacor ERV36 | Installation Instructions - Page 10
Installation Instructions Installation Preparation Verify service (electrical outlet) does not meet the Electrical Specifications on page 4, do not proceed with the installation. Call a licensed electrician and have an electrical outlet installed that meets the specifications. • Install the vent - Dacor ERV36 | Installation Instructions - Page 11
to the blower installation instructions. 2. Install the duct work according to the Installation Specifications. Use sheet metal screws and duct tape to connect and seal all of the pieces. Support the duct weight as necessary to ensure sealed joints. Anchor leg Front of raised vent REMP16 remote - Dacor ERV36 | Installation Instructions - Page 12
or non-functional system. Follow the wiring diagrams carefully to ensure a proper installation. Do not change the factory wired terminal connections inside the electrical access panel for the raised vent or the blower. • To avoid an electric shock hazard and to prevent damage route all wiring - Dacor ERV36 | Installation Instructions - Page 13
series remote blower Raised vent Connect wires/conduit according to remote blower installation instructions Range See ERV electrical access panel on facing page Floor Wiring/conduit from ERV to remote blower Example of Installation with Bottom Exhaust (Side View) Range Installation Install the - Dacor ERV36 | Installation Instructions - Page 14
the raised vent and to the blower itself?) □□ Are the vent filters installed according to these instructions? □□ Is the power cord routed away from the hot surfaces of the range. □□ Is the unit connected to an electrical outlet that meets the electrical specifications in these instructions? □□ Has - Dacor ERV36 | Installation Instructions - Page 15
DOWN LIMIT SWITCH COM NO NC Wiring Diagram UP LIMIT SWITCH COM NC NO RED SNORKEL SWITCH COM NO NC RED BLUE BLK YEL ORNG BLK YEL WHT WHT BLUE REMOTE POT RELAY N COM NO L SPEED CONTROL RED ORNG BLK CHASSIS GROUND STUD WHT L2 N2 L1 N1 GND GND BLOWER POWER OUTPUT INPUT GROUND 13 - Dacor ERV36 | Installation Instructions - Page 16
Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
Installation Instructions
Downdraft Raised Vent
Models:
ERV36-ER, ERV48-ER
Part No. 103106
Rev. H
Use these downdraft raised vents only with approved Dacor
®
appliances.
See the installation instructions for the particular appliance model being
installed to determine suitability.