Home » Dacor Manuals » Ovens » Dacor IWD30 » Manual Viewer

Dacor IWD30 Installation Instructions

Dacor IWD30 Manual

View all Dacor IWD30 manuals

Add to My Manuals
Save this manual to your list of manuals

Dacor IWD30 manual content summary:

Dacor IWD30 | Installation Instructions - Page 1
Installation Instructions Warming Drawer Models: ERWD27, ERWD30, EWD24, EWD27, EWD30, EWD36, IWD24, IWD27, IWD30, MRWD27, MRWD30, MWDH27, MWDH30, MWDV27, MWDV30, OWD24 Part No. 102345 Rev. Q
Dacor IWD30 | Installation Instructions - Page 2
All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
Dacor IWD30 | Installation Instructions - Page 3
Installation Planning 3 Install Support Platform in Cabinet 6 Electrical and Environmental Specifications 6 Installation Instructions 7 Remove the Drawer 7 Installing the Chassis 7 Re-installing the Drawer 8 Towel Rack Installation 8 Verify Warming Drawer Operation 9 Installation Checklist
Dacor IWD30 | Installation Instructions - Page 4
installation instructions. Have the installer show you the location of the electrical outlet so that you know where to disconnect power to the appliance. • Do not repair or replace any part of the warming drawer unless specifically recommended in the literature accompanying it. All other service
Dacor IWD30 | Installation Instructions - Page 5
builtin appliance. Proper installation is the customer's responsibility. • Carefully check the location where the drawer is to be installed. The drawer should be placed for convenient access. Make certain that electrical power can be provided in the selected location. Install the warming drawer in
Dacor IWD30 | Installation Instructions - Page 6
(75.2 cm) 26 5/8" (67.6 cm) 29 5/8" (75.2 cm) 25 1/4" (64.1 cm) 28 1/4" (71.8 cm) 25 1/4" (64.1 cm) 28 1/4" (71.8 cm) Warming Drawer Overall Dimensions See page 3 for IWD and OWD series chassis dimensions 23 3/8" (59.4 cm) ERWD 3 1/2" (8.9 cm) EWD 3 7/16" (8.7 cm) 1 1/8" (2.9 cm) 1" (2.5 cm
Dacor IWD30 | Installation Instructions - Page 7
36" typ. (91.4 cm) Cooktop 36" typ. (91.4 cm) Warming drawer Warming drawer A B 120 Vac electrical outlet 27"/30"/36" Dacor 3/4" min.* single wall oven C (1.9 cm) D D C Warming 120 Vac drawer elect. C 3/4" min.* D (1.9 cm) Warming 120 Vac drawer elect. C 1 1/2" (3.8 cm) Typical
Dacor IWD30 | Installation Instructions - Page 8
in poor warming drawer performance. Chassis face Support platform Electrical and Environmental Specifications warning IMPORTANT: This appliance is equipped /NFPA 70 and local codes and ordinances. • If the electrical service provided does not meet the product specification, or does not conform to
Dacor IWD30 | Installation Instructions - Page 9
caused by the appliance falling forward when the drawer is opened, secure the chassis to the cabinet and support platform as instructed. • Be face. 4. Use the screws provided to secure the warming drawer chassis to the cabinet and support platform, insert them into the mounting holes and tighten
Dacor IWD30 | Installation Instructions - Page 10
Repeat the same process on the opposite side. 6. Gently open and close the drawer to make sure that it is properly installed. Towel Rack Installation (OWD24 Only) Model OWD24 is designed so that it can be used as a towel warmer if desired. Other models are not equipped for this application. To use
Dacor IWD30 | Installation Instructions - Page 11
warming drawer does not operate properly, follow these troubleshooting steps: • Verify that the circuit breaker for the electrical outlet is on and not tripped. Make sure the power plug is connected. • Repeat the above tests. • If the appliance still does not work, contact Dacor Distinctive Service
Dacor IWD30 | Installation Instructions - Page 12
Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com