Dell E2723HN Monitor Teardown Instructions
Dell E2723HN Manual
 |
View all Dell E2723HN manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell E2723HN manual content summary:
- Dell E2723HN | Monitor Teardown Instructions - Page 1
1.Mechanical Instruction 1.1Disassembly Procedures Tools: 2 Power screwdrivers (φ=5mm, L=60mm); 1 small cross screwdriver; turnbuckle driver; Setting: Power screwdriver torque A=6 kgF.Cm Step Figure TOOl Remark Remove the stand - Dell E2723HN | Monitor Teardown Instructions - Page 2
Remove the mainframe Remove maylar Use scraper to insert from the bottom site and then open the rear cover Remove the tapes Disconnect the cables and remove the 2 pcs screws on the site of the mainframe and 2 pcs of hexagon screws - Dell E2723HN | Monitor Teardown Instructions - Page 3
Remove the powerbard and mainboard Remove the screws on the mainboard and power board Mainboard and powerboard 1.2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU - Dell E2723HN | Monitor Teardown Instructions - Page 4
1.3. Tools Required List the type and size of the tools that would typically can be used to disassemble the product to a point where components and materials requiring selective treatment can be removed. Tool Description: ‐ Screwdriver (Phillip-head, Hexagonal head) ‐ Penknife ‐ Soldering iron and
-
1 -
2 -
3 -
4
 |
 |
1.Mechanical Instruction
1.1Disassembly Procedures
Tools: 2 Power screwdrivers (φ=5mm
, L=60mm); 1 small cross screwdriver; turnbuckle driver;
Setting: Power screwdriver torque A=6 kgF.Cm
Step
Figure
TOOl
Remark
Remove the
stand
ass’y.
Pull up the stand
ass’y
Note:
Put the monitor on a
flat, soft and clean
surface.
Remove the
Rear cover
Remove the 6 pcs
screws .
T