Dell OptiPlex XE Mounting Your Dell™ OptiPlex™ XE Using a
Dell OptiPlex XE Manual
 |
View all Dell OptiPlex XE manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell OptiPlex XE manual content summary:
- Dell OptiPlex XE | Mounting Your Dell™ OptiPlex™ XE Using a - Page 1
for property damage, personal injury, or death. Mounting Your Dell™ OptiPlex™ XE Using a Wall-Mount Unit WARNING: Before working inside your computer, at www.dell.com/regulatory_compliance. NOTE: The size of the wall-mount unit differs based on the computer's form factor. 1 If you are mounting a - Dell OptiPlex XE | Mounting Your Dell™ OptiPlex™ XE Using a - Page 2
2 Mount the wall-mount unit to the wall using the screws that shipped with the unit. - Dell OptiPlex XE | Mounting Your Dell™ OptiPlex™ XE Using a - Page 3
3 Place the computer into the wall-mount unit. Without the IP51 kit With the IP51 kit - Dell OptiPlex XE | Mounting Your Dell™ OptiPlex™ XE Using a - Page 4
4 Replace the two screws on the wall-mount unit. Without the IP51 kit With the IP51 kit Information in this document is subject to change without notice. © 2010 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.
-
1 -
2 -
3 -
4
 |
 |
About Warnings
WARNING:
A WARNING indicates a potential for property damage, personal injury,
or death.
Mounting Your Dell™ OptiPlex™ XE Using
a Wall-Mount Unit
WARNING:
Before working inside your computer, read the safety information that
shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
The size of the wall-mount unit differs based on the computer’s form factor.
1
If you are mounting a computer with the optional Ingress Protection 51 (IP51)
kit attached, remove the paddings from the wall-mount unit.
February 2010