Dell P2425 Monitor Teardown Instructions
Dell P2425 Manual
![]() |
View all Dell P2425 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell P2425 manual content summary:
- Dell P2425 | Monitor Teardown Instructions - Page 1
DELL P2425B 1 1. Disassembly Procedures S1 Turn off the monitor. S2 Place the monitor on a soft cloth or cushion release button at the back of the display Lift the stand assembly up and away from the monitor S3 Unlock 4 screws on "Rear Cover" S6 Unlock 3 screws to disassemble "Control board" - Dell P2425 | Monitor Teardown Instructions - Page 2
DELL P2425B 2 S8 Tear off a black tape from "USB board FFC" and "Panel S10 Disassemble "USB board" from "USB Shielding" Disassemble "USB board FFC" from "USB - Dell P2425 | Monitor Teardown Instructions - Page 3
DELL P2425B 3 S12 Tear off a long tape from "LVDS FFC" Disassemble "LVDS FFC" from "Panel" Take off "Main Shielding" from "Panel" S15 Unlock 2 hexagonal screws S13 - Dell P2425 | Monitor Teardown Instructions - Page 4
DELL P2425B 4 S18 Remove electrolyte capacitors (red mark) from printed circuit boards S18-1 Cut the glue between bulk cap. and PCB with a knife S18-2 Ensure cutting path within the glue, don't touch bulk cap. or PCB - Dell P2425 | Monitor Teardown Instructions - Page 5
DELL P2425B 5 S18-3 Take out bulk cap. pin solder with soldering iron and absorber S18-4 Lift the bulk cap. up and away from the PCB - Dell P2425 | Monitor Teardown Instructions - Page 6
DELL P2425B 6 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of
![](/manual_guide/products/dell-p2425-monitor-teardown-instructions-7d427be/1.png)
1
DELL P2425B
1. Disassembly Procedures
S1
Turn off the monitor.
S2
Place the monitor on a soft cloth or
cushion
Press and hold the stand release button
at the back of the display
Lift the stand assembly up and away
from the monitor
S3
Unlock 4 screws on “Rear Cover”
(Screw Torque: 9±1 kgf)
S4
Use hands or “Bar Scraper” to
disassemble “Rear Cover” from “Middle
Frame” according to the sequence
shown in the picture
S5
Pull out “Control board FFC” from
“Interface board” and tear off it from
“Main Shielding” to take off “Rear
Cover”
S6
Unlock 3 screws to disassemble
“Control board” from “Rear Cover”
Tear off “Control board FFC” from
“Rear Cover” and take off “Control
board” from “Rear Cover”
(Screw Torque: 1.6-1.8 kgf)
S7
Disassemble “Control board FFC” from
“Control board”