Dell P2425H Monitor Teardown Instructions
Dell P2425H Manual
![]() |
View all Dell P2425H manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell P2425H manual content summary:
- Dell P2425H | Monitor Teardown Instructions - Page 1
DELL P2425HB 1 1. Disassembly Procedures S1 Turn off the monitor. S2 Place the monitor on a soft cloth or cushion release button at the back of the display Lift the stand assembly up and away from the monitor S3 Unlock 4 screws on "Rear Cover" S6 Unlock 3 screws to disassemble "Control board" - Dell P2425H | Monitor Teardown Instructions - Page 2
S8 Tear off an aluminum foil mylar from "Main Shielding" DELL P2425HB 2 S10 Tear off a gasket from "USB Shielding" (see pink mark) Tear off a gasket from "USB board" (see red mark) S11 Disassemble "USB board" from " - Dell P2425H | Monitor Teardown Instructions - Page 3
DELL P2425HB 3 S13 Tear off 3 conductive tapes from "Main Shielding and "Panel" S16 Disassemble "MYLAR" from "Main Shielding" S14 Tear off a long tape from "LVDS FFC" - Dell P2425H | Monitor Teardown Instructions - Page 4
DELL P2425HB 4 S20 Remove electrolyte capacitors (red mark) from printed circuit boards S20-1 Cut the glue between bulk cap. and PCB with a knife S20-2 Ensure cutting path within the glue, don't touch bulk cap. or PCB - Dell P2425H | Monitor Teardown Instructions - Page 5
DELL P2425HB 5 S20-3 Take out bulk cap. pin solder with soldering iron and absorber S20-4 Lift the bulk cap. up and away from the PCB - Dell P2425H | Monitor Teardown Instructions - Page 6
DELL P2425HB 6 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of
![](/manual_guide/products/dell-p2425h-monitor-teardown-instructions-2916fe6/1.png)
1
DELL P2425HB
1. Disassembly Procedures
S1
Turn off the monitor.
S2
Place the monitor on a soft cloth or
cushion
Press and hold the stand release button
at the back of the display
Lift the stand assembly up and away
from the monitor
S3
Unlock 4 screws on “Rear Cover”
(Screw Torque: 9±1 kgf)
S4
Use hands or “Bar Scraper” to
disassemble “Rear Cover” from “Middle
Frame” according to the sequence
shown in the picture
S5
Pull out “Control board FFC” from
“Interface board” and tear off it from
“Main Shielding” to take off “Rear
Cover”
S6
Unlock 3 screws to disassemble
“Control board” from “Rear Cover”
Tear off “Control board FFC” from “Rear
Cover” and take off “Control board”
from “Rear Cover”
(Screw Torque: 1.6-1.8 kgf)
S7
Disassemble “Control board FFC” from
“Control board”