Dell P2723DE USB-C Monitor Teardown Instructions
Dell P2723DE Manual
![]() |
View all Dell P2723DE manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell P2723DE manual content summary:
- Dell P2723DE | USB-C Monitor Teardown Instructions - Page 1
1.Mechanical Instruction 1.1Disassembly Procedures Tools: 2 Power screwdrivers (φ=5mm, L=60mm); 1 small cross screwdriver; turnbuckle driver; Setting: Power screwdriver torque A=6 kgF.Cm Step Figure Remark Remove Stand ass'y Remove - Dell P2723DE | USB-C Monitor Teardown Instructions - Page 2
Remove the rear cover Use scraper to insert from the right site and then open the rear cover Disconnect the cables open the cover on the keyboard/ usb board and then pull out the cables - Dell P2723DE | USB-C Monitor Teardown Instructions - Page 3
Remove the mainframe Remove the mylar Remove the powerbard and mainboard and converter board Remove the two screws on the mainframe and then disconnect the FFC cables Remove the screws on the mainboard and power board - Dell P2723DE | USB-C Monitor Teardown Instructions - Page 4
Remove the usb board Remove the keyboard Remove the middle frame Remove the screw on the usb board Remove the 3pcs screws on the keyboard Remove the screws on the middle frame - Dell P2723DE | USB-C Monitor Teardown Instructions - Page 5
Mainboard and powerboard and coverter board panel 1.2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU Council Directive 75/442/EEC. Capacitors / condensers ( - Dell P2723DE | USB-C Monitor Teardown Instructions - Page 6
Gas discharge lamps LCD display > 100 cm2 External electric cable Component contain refractory ceramic fibers Component contain radio-active substances Electrolyte capacitors (height > 25mm, diameter > 25mm) No used Product has an LCD greater than 100 cm2 Product has external cables No used No used
![](/manual_guide/products/dell-p2723de-usbc-monitor-teardown-instructions-bb69822/1.png)
1.Mechanical Instruction
1.1Disassembly Procedures
Tools: 2 Power screwdrivers (φ=5mm
, L=60mm); 1 small cross screwdriver; turnbuckle driver;
Setting: Power screwdriver torque A=6 kgF.Cm
Step
Figure
Remark
Remove S
tand
ass’y
Press the button marked
red and remove the
stand ass’y
Remove the
rear cover
Remove the 4 pcs
screws .