Dell P2725H Monitor Teardown Instructions
Dell P2725H Manual
 |
View all Dell P2725H manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell P2725H manual content summary:
- Dell P2725H | Monitor Teardown Instructions - Page 1
DELL P2725HB 1 1. Disassembly Procedures S1 Turn off the monitor. S2 Place the monitor on a soft cloth or cushion S5 Pull out "Control board FFC" from "Interface - Dell P2725H | Monitor Teardown Instructions - Page 2
DELL P2725HB 2 S8 Tear off a black tape from "USB board FFC" and "Panel" Disassemble "USB board FFC" from "USB board" and "Interface board" Unlock 1 screw on " - Dell P2725H | Monitor Teardown Instructions - Page 3
DELL P2725HB 3 S13 Tear off a long tape from "LVDS FFC" Disassemble "LVDS FFC" from "Panel" Take off "Main Shielding" from "Panel" S16 Unlock 2 hexagonal screws (Screw - Dell P2725H | Monitor Teardown Instructions - Page 4
DELL P2725HB 4 S19 Remove electrolyte capacitors (red mark) from printed circuit boards S19-1 Cut the glue between bulk cap. and PCB with a knife S19-2 Ensure cutting path within the glue, don't touch bulk cap. or PCB - Dell P2725H | Monitor Teardown Instructions - Page 5
DELL P2725HB 5 S19-3 Take out bulk cap. pin solder with soldering iron and absorber S19-4 Lift the bulk cap. up and away from the PCB - Dell P2725H | Monitor Teardown Instructions - Page 6
DELL P2725HB 6 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of
-
1 -
2 -
3 -
4 -
5 -
6
 |
 |
1
DELL P2725HB
1. Disassembly Procedures
S1
Turn off the monitor.
S2
Place the monitor on a soft cloth or
cushion
Press and hold the stand release button
at the back of the display
Lift the stand assembly up and away
from the monitor
S3
Unlock 4 screws on “Rear Cover”
(Screw Torque: 9±1 kgf)
S4
Use hands or “Bar Scraper” to
disassemble “Rear Cover” from “Middle
Frame” according to the sequence
shown in the picture
S5
Pull out “Control board FFC” from
“Interface board” and tear off it from
“Main Shielding” to take off “Rear
Cover”
S6
Unlock 3 screws to disassemble
“Control board” from “Rear Cover”
Tear off “Control board FFC” from “Rear
Cover” and take off “Control board”
from “Rear Cover”
(Screw Torque: 1.6-1.8 kgf)
S7
Disassemble “Control board FFC” from
“Control board”