Dell PowerEdge M420 Processor Heat Sink Installation Information
Dell PowerEdge M420 Manual
View all Dell PowerEdge M420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell PowerEdge M420 manual content summary:
- Dell PowerEdge M420 | Processor
Heat Sink Installation Information - Page 1
Installation Information NOTICE: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide sink retention screws when installing the heat sink. To prevent over-tightening, Dell recommends that you - Dell PowerEdge M420 | Processor
Heat Sink Installation Information - Page 2
Dell 6 in-lb (6.9 kg-cm)。 2007 Dell Inc Dell Inc Dell 和 DELL 徽标是 Dell Inc Dell Inc 2007 年 11 月 - Dell PowerEdge M420 | Processor
Heat Sink Installation Information - Page 3
installation du dissipateur de chaleur du processeur AVIS : Seuls les techniciens de maintenance qualifiés sont habilités à retirer le capot du système pour accéder aux composants internes. Consultez le document Product Information Guide (Guide plus que nécessaire. Dell recommande de visser - Dell PowerEdge M420 | Processor
Heat Sink Installation Information - Page 4
Prozessorkühlkörper - Hinweise zur Installation HINWEIS: Nur zugelassene Servicetechniker dürfen die ühren. Ziehen Sie die Verschlussschrauben des Kühlkörpers beim Einbau nicht zu fest an. Dell empfiehlt, die Verschlussschrauben so lange anzuziehen, bis Widerstand spürbar ist und mit dem Festziehen - Dell PowerEdge M420 | Processor
Heat Sink Installation Information - Page 5
6.9 kg-cm 2007 Dell Inc Printed in Ireland. Dell Inc Dell および DELL ロゴは Dell Inc Dell Inc 2007 年 11 月 - Dell PowerEdge M420 | Processor
Heat Sink Installation Information - Page 6
6 in-lb (6.9 kg-cm 2007 Dell Inc. All rights reserved Dell Inc Dell 및 DELL 로고는 Dell Inc Dell Inc 2007 년 11 월 - Dell PowerEdge M420 | Processor
Heat Sink Installation Information - Page 7
en exceso los tornillos de retención del disipador de calor al instalarlo. Para evitar que los tornillos de retención queden excesivamente apretados, Dell recomienda enroscarlos hasta que se note resistencia y detenerse una vez que el tornillo quede asentado. La tensión del tornillo no puede ser
Processor Heat Sink
Installation Information
NOTICE:
Only trained service technicians are authorized to remove the system cover
and access any of the components inside the system. See your Product Information
Guide for complete information about safety precautions, working inside the computer,
and protecting against electrostatic discharge.
NOTICE:
The processor and heat sink can become extremely hot. Be sure the
processor has had sufficient cooling time to cool before handling.
Do not over-tighten the heat sink retention screws when installing the heat sink.
To prevent over-tightening, Dell recommends that you tighten the retention
screw until resistance is felt and stop once the screw is seated. The screw tension
should be no more than 6 in-lb (6.9 kg-cm).
____________________
Information in this document is subject to change without notice.
© 2007 Dell Inc. All rights reserved. Printed in Ireland.
Reproduction in any manner whatsoever without the written permission of Dell Inc.
is strictly forbidden.
Trademarks used in this text:
Dell
and the
DELL
logo
are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the
marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade
names other than its own.
November 2007