Dell PowerEdge M620 Brocade SAN Tech Note: Preparing to Install the Brocade Ac

SAN TECH NOTE

Preparing to Install the

Brocade Access Gateway

I

NTRODUCTION

This SAN Tech Note describes configuration parameters that must be implemented to integrate the

Brocade

®

M4424 SAN I/O Module for the Dell

™

PowerEdge

™

M1000e in Access Gateway mode into a

Storage Area Network (SAN) fabric. The following describes the parameters for the Edge device that

will be connected to the Brocade Access Gateway.

C

ONNECTING TO

B

ROCADE

F

ABRICS

Fabric OS Switches

Ensure that all the following conditions are met:

•

Fabric OS

®

5.2.1 recommended

Fabric OS 5.1.0 or later also supported

•

NPIV must be enabled on SAN switch N_Ports that will connect to the Access Gateway.

•

Management Server platform services must be disabled before the Access Gateway is connected

to the fabric. (Management Server platform services can be enabled after you complete the

setup.)

•

Allow inband inquiries, such as GFN and GML, and registration commands, such as RPL and RPAB

to the Management Server.

•

Set Management Server access set to “all access.” If set to “restricted,” include all AG N_Port

WWNs in the MS access control list

•

Fabric and switch zoning rules must use the WWN zoning scheme.

•

Switch and fabric ACL (Access Control List) policies, if present, must include the WWN of the

Access Gateway N_Ports and/or the host WWNs.

•

Fabric logins on the port and switch that connect the Access Gateway to the SAN set to the

maximum.