Dell PowerEdge UPS 500T Setting Up Your Network Management Card
Dell PowerEdge UPS 500T Manual
 |
View all Dell PowerEdge UPS 500T manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell PowerEdge UPS 500T manual content summary:
- Dell PowerEdge UPS 500T | Setting Up Your Network Management Card - Page 1
package contents 1. Network Management Card 2. Serial cable 3. Setup instructions 4. Safety, Enviromental, and Regulatory Information MAC address 2 Note Settings Port even if the network is not connected www.dell.com | support.dell.com 3 Remove the cover from the UPS communication bay - Dell PowerEdge UPS 500T | Setting Up Your Network Management Card - Page 2
available in other languages at: support.dell.com Français Ce document de configuration et le Guide d'Utilisation de la Carte de Gestion de Réseau Dell sont disponibles dans d'autres langues sur : support.dell.com www.dell.com | support.dell.com Deutsch Das vorliegende Dokument zur Konfiguration
-
1 -
2
 |
 |
www.dell.com | support.dell.com
1
4
2
5
3
6
www.dell.com
www.dell.com
Setting Up Your Network Management Card
Verify the package contents
1. Network Management Card
2. Serial cable
3. Setup instructions
4. Safety, Enviromental, and
Regulatory Information
Insert and secure the card
with the retaining screws
Note the MAC address on the card
Connect an Ethernet cable to the card
and to the network (not supplied)
NOTE: You can set the card parameters
via the Settings Port even if the network is
not connected
Remove the cover from the
UPS communication bay
Wait approximately two
minutes until the UPS Data
LED flashes regularly,
indicating normal operation
ACT
100M
UPS Data
RS232
Ethernet Port (10/100BaseT)
ACT LED (green)
Off
Card is not connected
to the network
On
Card is connected
to the network,
but no activity
Flashing
Port is sending/
receiving
100M LED (orange)
Off
Port is operating
at 10 Mbits/s
On
Port is operating
at 100 Mbits/s
Settings Port
UPS Data LED (green)
Off
Card is starting
On
Card is communicating
with the UPS
Flashing
Normal operation;
communication with
the UPS is operational
RS232 LED (orange)
On
Configuration menu
is activated
Off
Normal operation;
Configuration menu
is not activated
UPS Data LED flashing
MAC address
About Your Network Management Card
1. Ethernet port (10/100BaseT)
2. ACT LED (green)
3. 100M LED (orange)
4. Settings port
5. UPS Data LED (green)
6. RS232 LED (orange)
2
3
1
1
2
3
4
5
6
4