Dell S2722DZ Monitor Teardown Instructions
Dell S2722DZ Manual
View all Dell S2722DZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell S2722DZ manual content summary:
- Dell S2722DZ | Monitor Teardown Instructions - Page 1
1 DELL S2722DZ 1. Disassembly Procedures: S1 Open the carton with a proper tool. Use a the carton. (Note: It depends on whether users returning the accessories) power cable QSG USB Type-C cable manual Take out the base and molded pulp from the carton, S3 then take out the monitor and stand from - Dell S2722DZ | Monitor Teardown Instructions - Page 2
DELL S2722DZ 2 2 3 5 4 6 2 1 3 4 1 Release the speakers from the probers of the middle bezel, then tear off 1pcs aluminum foil to uncover the two LVDS connector, and then disconnect - Dell S2722DZ | Monitor Teardown Instructions - Page 3
3 DELL S2722DZ Use a Philips-head screwdriver to remove 4pcs screws for unlocking the camera board, and then S12 remove assembled camera unit and put it aside for - Dell S2722DZ | Monitor Teardown Instructions - Page 4
DELL S2722DZ 4 Put the middle bezel into a fixture. Use a Philipshead screwdriver to remove 2pcs screws to unlock the right and left Mic board, then release the right - Dell S2722DZ | Monitor Teardown Instructions - Page 5
5 DELL S2722DZ Remove electrolyte capacitors (red mark) from S22 printed circuit boards. S22-4 Take out bulk cap. pin solder with soldering iron and absorber. S22-1 Cut the - Dell S2722DZ | Monitor Teardown Instructions - Page 6
DELL S2722DZ 6 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU
1
DELL S2722DZ
Use a Philips-head screwdriver to remove 4pcs
screws for unlocking rear cover with the assembled
unit.
(No.1~4 screw size=M4x11; Torque=11
±
1kgfxcm)
Take out all accessories including label(optinal), QSG,
USB Type-C cable, power cable, manual and other
packing materials from the carton. (Note: It depends
on whether users returning the accessories)
S2
Open the carton with a proper tool.
1
.
Disassembly Procedures:
S1
Take out the monitor from EPE-bag and put the LCD
monitor on a protective cushion.
Take out the base and molded pulp from the carton,
then take out the monitor and stand from the carton.
S3
S4
S5
Wedge your fingers between rear cover and the
middle bezel on the corners of the top side of the
monitor to release the rear cover, then use one hand
to press the middle bezel, the other hand to pull up
carefully the rear cover in order of arrow preference
for unlocking mechanisms of rear cover. Remove the
rear cover and put it aside.
S6
S7
Tear off 2pcs aluminum foils, disconnect the Mic wire
and speaker’s cable away from the connectors of the
interface board. Use a Philips-head screwdriver to
remove 6pcs screws for unlocking the two speakers.
(No.1~6 screw size=M3x3.5, Torque=3~4 kgfxcm)
2
3
4
1
3
2
1
2
QSG
USB Type-C cable
power cable
manual
base
monitor
stand