Dell U2724DE UltraSharp 27 Thunderbolt Hub Monitor – Teardown Instr
Dell U2724DE Manual
![]() |
View all Dell U2724DE manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell U2724DE manual content summary:
- Dell U2724DE | UltraSharp 27 Thunderbolt Hub Monitor – Teardown Instr - Page 1
1. Disassembly Procedures: S1 Turn off power.. Unplug external cables(power cable and video S2 cable) from the monitor. DELL U2724DE 1 Wedge your fingers between rear cover and the middle bezel on the corners of the top side of the monitor to release the rear cover, - Dell U2724DE | UltraSharp 27 Thunderbolt Hub Monitor – Teardown Instr - Page 2
2 DELL U2724DE 2 1 Use a Philips-head screwdriver to release one screw for unlocking the USB board, then release the USB S8 board from the hooks of the middle - Dell U2724DE | UltraSharp 27 Thunderbolt Hub Monitor – Teardown Instr - Page 3
DELL U2724DE 3 Move up the bracket, then push the earing-lock and S14 disconnect the EDP cable away from the connectors of the panel module. Use a Philips- - Dell U2724DE | UltraSharp 27 Thunderbolt Hub Monitor – Teardown Instr - Page 4
4 DELL U2724DE Remove electrolyte capacitors (red mark) from S20 printed circuit boards. S20-4 Take out bulk cap. pin solder with soldering iron and absorber. S20-1 Cut the - Dell U2724DE | UltraSharp 27 Thunderbolt Hub Monitor – Teardown Instr - Page 5
DELL U2724DE 5 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU
![](/manual_guide/products/dell-u2724de-ultrasharp-27-thunderbolt-hub-monitor-x2013-teardown-instructions-b153889/1.png)
1
DELL U2724DE
Unplug external cables(power cable and video
cable) from the monitor.
S2
Turn off power..
1.
Disassembly Procedures:
S1
Remove stand from the product.(Press the stand
release button, lift the stand up and away from the
monitor)
S3
S4
S5
S6
S7
screws for unlocking mechanisms. Remove 3pcs DP
caps.
(No.1~4 screw size=M4x11; Torque=11
±
1kgfxcm)
Use a Philips-head screwdriver to remove 4pcs
Wedge your fingers between rear cover and the
middle bezel on the corners of the top side of the
monitor to release the rear cover, then use one hand
to press the middle bezel, the other hand to pull up
carefully the rear cover in order of arrow preference
for unlocking mechanisms of rear cover.
Lift the rear cover up carefully. Disconnect the
joystick key cable and sensor cable from the
connectors of the interface board, and then remove
the rear cover.
Tear off all tape to release the cables and release
sensor board from the hook of the rear cover. Use a
Philips-head screwdriver to remove 2pcs screw for
unlocking the key board.
(No.1
~
2 screw size=M2x2.4, Torque=0.8
~1
kgfxcm)
2
3
4
1
3
2
1
2