Dell U3223QE Monitor Teardown Instructions
Dell U3223QE Manual
 |
View all Dell U3223QE manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell U3223QE manual content summary:
- Dell U3223QE | Monitor Teardown Instructions - Page 1
DELL U3223QE 1 1. Disassembly Procedures: S1 Open the carton with a proper tool. Use a Philips-head DP cable USB C to C cable USB A to C cable manual Take out the paper top with base from the carton, S3 then take out the monitor and stand from the carton. base Tear off the screen protector, then - Dell U3223QE | Monitor Teardown Instructions - Page 2
2 DELL U3223QE Tear off 1pcs aluminum foil for unfixing the bracket, S9 then tear off 1pcs acetate tape for uncovering the LVDS connector . Use a Philips-head screwdriver - Dell U3223QE | Monitor Teardown Instructions - Page 3
DELL U3223QE 3 Release the panel lamp cables from the hooks of the S18 bracket, then remove the Mylar tape from the hooks of the bracket. Move up - Dell U3223QE | Monitor Teardown Instructions - Page 4
4 DELL U3223QE Remove electrolyte capacitors (red mark) from S21 printed circuit boards. S21-4 Take out bulk cap. pin solder with soldering iron and absorber. S21-1 Cut the - Dell U3223QE | Monitor Teardown Instructions - Page 5
DELL U3223QE 5 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU
-
1 -
2 -
3 -
4 -
5
 |
 |
1
DELL U3223QE
Use a Philips-head screwdriver to remove 4pcs
screws for unlocking mechanisms. Remove DP caps.
(No.1~4 screw size=M4x11; Torque=11
±
1kgfxcm)
Take out all accessories including label(optinal), QSG,
Delta-E paper, DP cable, USB C to C cable(Type-C
cable), USB A to C cable(USB cable), power cable,
manual from the carton. (Note: It depends on whether
users returning the accessories)
S2
Open the carton with a proper tool.
1
.
Disassembly Procedures:
S1
Take out the monitor from EPE-bag and put the LCD
monitor on a protective cushion.
Take out the paper top with base from the carton,
then take out the monitor and stand from the carton.
S3
S4
S5
S6
S7
3
2
1
2
Lift the rear cover up carefully. Disconnect the
joystick key cable from the connector of the interface
board, and then remove the rear cover and put it
aside for later disassembling.
Use a Philips-head screwdriver to remove 2pcs
screw for unlocking the key board, then tear off the
tapes and release the key board.
(No.1
~
2 screw size=M2x2.4, Torque=0.8
~1
kgfxcm)
S8
base
monitor
stand
1
2
2
3
4
1
Delta_E paper
QSG
USB A to C cable
DP cable
power cable
USB C to C cable
manual
Tear off the screen protector, then wedge fingers
between rear cover and the middle bezel on the
corners of the top side of the monitor to release the
rear cover, then use one hand to press the middle
bezel, the other hand to pull up the rear cover in order
of arrow preference
for unlocking the rear cover.