Dell W-Series 314 310 Series Regulatory Compliance and Safety Information Guid

Dell W-Series 314 Manual

Dell W-Series 314 manual content summary:

  • 1
  • 2
  • 3
  • 4

Dell Networking 310 Series Access Points
Regulatory Compliance and Safety Information Guide
0511905-01 |
May 2016
1
Introduction
This document contains domestic and international regulatory compliance and safety information for Dell Networking 310 Series access points (W-AP314, W-
AP315, W-IAP314, and W-IAP315). To ensure that this device complies with the regulatory standards for your region, please refer to the sections below.
Electrical and Environmental Specifications
Regulatory Information
Proper Disposal of Dell Equipment
Electrical and Environmental Specifications
For additional specifications on this product, please refer to the product data sheet at
dell.com.
Electrical
Ethernet:
100/1000 Base-T auto-sensing Ethernet RJ45 interface
IEEE 802.3u (100 Base-T). IEEE 802.3ab (1000 Base-T)
Power over Ethernet IEEE 802.3at 56VDC (nominal) and 802.3af 48VDC (maximum).
Power:
48VDC power interference, support powering through an AC-to-DC power adapter (AP-AC-48V36B)
Maximum power consumption (excluding USB): 20W (PoE) or 18.5W (DC)
Environmental
Operating:
Temperature: 0
°
C to +50
°
C (+32
°
F to +122
°
F)
Humidity: 5% to 93% non-condensing
Storage and transport:
Temperature: -40
°
C to +70
°
C (40
°
F to +158
°
F)
Regulatory Information
The following regulatory model names apply to the 310 Series access points:
W-AP314/W-IAP314: APIN0314
W-AP315/W-IAP315: APIN0315
CAUTION:
All Dell access points should be professionally installed by a certified technician. The installer is responsible for ensuring that
grounding is available and meets applicable national and electrical codes.
ATTENTION:
Tous les points d'accès Dell doivent impérativement être installés par un professionnel agréé. Ce dernier doit s'assurer que
l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques nationaux en vigueur.
NOTE:
If a power adapter other than the Dell-approved adapter is used in the US or Canada, it should be NRTL listed, without an output rated
48VDC, minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into a standard power receptacle in the US and Canada.
NOTE:
For country specific restrictions and additional regulatory and safety guidelines, refer to the
Dell Networking W-Series Safety,
Environmental and Regulatory Information
document included with Dell controllers and Instant access points.