Dynex DX-400WPS FAQs (English)

Dynex DX-400WPS Manual

Get Dynex DX-400WPS PDF manuals and user guides View all Dynex DX-400WPS manuals
Add to My Manuals
Save this manual to your list of manuals

Dynex DX-400WPS manual content summary:

  • Dynex DX-400WPS | FAQs (English) - Page 1
    FAQs Dynex 400-Watt ATX Power Supply (DX-400WPS) June 30, 2011 Setup...1 Wire Configuration ...4 Hardware Issues ...4 General ...5 Setup 1. How do I set up my Power Supply?  Have you tried using your User Guide to help you through this process? If more help is needed, follow the steps below. a.
  • Dynex DX-400WPS | FAQs (English) - Page 2
    your notes from when you removed the old power supply to make sure you are making all connections which were previously in place. a. Connect the 20+4-pin main power connector to your motherboard. b. Connect the 8-pin (4+4) or 4-pin +12 V power connectors to your motherboard. c. Connect all of the
  • Dynex DX-400WPS | FAQs (English) - Page 3
    . iv. The 6-pin +12V power connector(s) to the PCI-E graphic card(s). g. Connect your case fans to the regular 4-pin peripheral connectors if you are using these fans. h. Replace the side panel closing the computer case. i. Connect the AC power cord to the power supply. j. Switch the Power on. 3
  • Dynex DX-400WPS | FAQs (English) - Page 4
    look like? Hardware Issues 3. Nothing happens when I try to start up my computer.  Make sure the computer power cable is firmly plugged into the power cord connector on your power supply. This power cable will extend out the back of your computer.  If you are using a surge protector, make sure
  • Dynex DX-400WPS | FAQs (English) - Page 5
    General 4. Where can I get more information about my power supply?  Refer to your User Guide or the Dynex Website: o http://www.dynexproducts.com/products/computers/DX-400WPS.html 5. Is someone available to install the power supply for me?  Visit your local Best Buy Geek Squad for assistance or
  • 1
  • 2
  • 3
  • 4
  • 5
FAQs
Dynex 400-Watt ATX Power Supply
(DX-400WPS)
June 30, 2011
Setup
...............................................................................................................................................
1
Wire Configuration
........................................................................................................................
4
Hardware Issues
............................................................................................................................
4
General
...........................................................................................................................................
5
Setup
1.
How do I set up my Power Supply?
Have you tried using your User Guide to help you through this process? If more
help is needed, follow the steps below.
a.
Turn your computer off.
b.
Unplug the power cable from your computer.
c.
Remove the side panel on your computer, so you can access the power
supply and connectors.
d.
Disconnect all power supply connections from the motherboard and
peripheral devices, such as hard drives, optical drives, video cards and
fans.
Make sure to note cables you are removing for when you need
to reconnect them later
.
e.
Remove the old power supply from your computer case and install your
new Dynex power supply, securing it to the computer case with the
appropriate screws.