Dynex DX-TRPMN57 Quick Setup Guide (English)

Dynex DX-TRPMN57 Manual

Get Dynex DX-TRPMN57 PDF manuals and user guides View all Dynex DX-TRPMN57 manuals
Add to My Manuals
Save this manual to your list of manuals

Dynex DX-TRPMN57 manual content summary:

  • Dynex DX-TRPMN57 | Quick Setup Guide (English) - Page 1
    Reserved. DX-TRPMN57 57" Compact Tripod-Monopod Combo 4 To adjust the height, unscrew the leg twist locks, extend the leg to the height you want, then tighten the leg locks. V1 ENGLISH 14-0371 Before using your new product, please read these instructions to prevent any damage. QUICK SETUP GUIDE
  • Dynex DX-TRPMN57 | Quick Setup Guide (English) - Page 2
    Package contents • Tripod • Carrying case • Quick Setup Guide Features • Compact portable size, with built in bubble level, can support a camera up to 8.8 Ibs (4 kg) • One leg conversion to use as a monopod • Super-low 6.7 in. (17 cm) shooting angle • Reversed folding reduces storage space
  • 1
  • 2
Center column
Hanging hook
Monopod leg
V1 ENGLISH 14-0371
Storing your tripod
1
Remove your camera.
2
Loosen the center column locks. Raise the column as far as it
will go, then tighten the bottom lock. Lower the top section as
far as it will go.
3
Twist each leg lock counterclockwise and collapse the legs.
4
Wrap your hand around all four leg locks, then twist clockwise
to tighten them all at once.
5
Pull out the leg release tabs and flip the legs up.
Note
: You may need to rotate the head slightly so the legs fit between
the knobs.
6
Store the tripod into the carrying case.
Important safety instructions
•
Make sure that all leg locks are correctly tightened and that the
legs are fully opened before use.
•
Do not carry or transport your tripod with camera equipment
attached (for example, over your shoulder or cradled in your
arms).
•
Do not expose your tripod to excessive heat or cold, or use near
any flame or fire.
•
Do not oil or grease any part of the tripod.
•
Do not use any solvents or thinners to clean your tripod. Use
only a mild detergent and wipe dry with a soft, lint-free cloth.
•
Do not exceed the load limit of this tripod.
Specifications
•
Maximum operating height: 57.1 in. (145 cm)
•
Minimum operating height: 6.7 in. (17 cm)
•
Folded height (reversed legs): 13.4 in. (34 cm)
• Net weight: 2.7 lbs (1.24 kg)
•
Max operating load: 8.8 lb (4 kg)
• Number of leg sections: 5
•
Quick release thread: 1/4 in. (0.6 cm)
•
Panoramic angle: horizontal: 360° and vertical: 90°
• Material: aluminum alloy
One-year limited warranty
Visit www.dynexproducts.com for details.
Contact Dynex:
For customer service, call 800-305-2204 (U.S. and Canada) or
01-800-926-3020 (Mexico)
www.dynexproducts.com
DYNEX is a registered trademark of BBY Solutions, Inc.
Registered in some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2014 BBY Solutions, Inc. All Rights Reserved.
QUICK SETUP GUIDE
DX-TRPMN57
57" Compact
Tripod-Monopod Combo
Before using your new product, please read
these instructions to prevent any damage.
Converting to a monopod
1
Holding the tripod firmly, unscrew the monopod leg from the
main tripod assembly.
2
Unscrew the center column locking screws, unscrew the bottom
hanging hook, then remove the center column from the tripod
base.
3
Screw the center column (with ball head) into the monopod leg.
4
To adjust the height, unscrew the leg twist locks, extend the leg
to the height you want, then tighten the leg locks.