Electrolux EI30MH55GZ Installation Instructions

Electrolux EI30MH55GZ - 2.1 cu. ft. Microwave Oven Manual

Get Electrolux EI30MH55GZ - 2.1 cu. ft. Microwave Oven PDF manuals and user guides
UPC - 012505559396
View all Electrolux EI30MH55GZ manuals
Add to My Manuals
Save this manual to your list of manuals

Electrolux EI30MH55GZ manual content summary:

  • Electrolux EI30MH55GZ | Installation Instructions - Page 1
    people are recommended to install this product. • If a new electrical outlet is required, its installation should be completed by a qualified electrician before the Over the Range Microwave Oven is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 2. 1 MOUNTING SPACE This Over the Range
  • Electrolux EI30MH55GZ | Installation Instructions - Page 2
    be located inside the cabinet directly above the Microwave Oven mounting location as shown in Figure 2. NOTES: 1. If you have any questions about the grounding or electrical instructions, consult a qualified electrician or serviceperson. 2. Neither Electrolux nor the dealer can accept any liability
  • Electrolux EI30MH55GZ | Installation Instructions - Page 3
    Installation Instructions 6 INSTALLATION HARDWARE The INSTALLATION HARDWARE items 1 - 7 are in a small bag. Items 8 - " are packed separately. All items are in a small carton packed below the oven. Item 1 2 3 4 5 6 7 8 9 ! " Name Quantity Wood Screw 5 x 30 mm 6* Toggle Bolt with nuts #
  • Electrolux EI30MH55GZ | Installation Instructions - Page 4
    directions as the arrow. Use 1 Tapping Screw 4 x 12 mm from the INSTALLATION HARDWARE and tighten into place. See Figure 10B. 6. This assembly will be mounted to the Outside Rear Exhaust cutout in future instructions. (A) Rotate 180˚ (B) Figure 9 Figure 10A Exhaust Damper Assembly Fan Cover Bracket
  • Electrolux EI30MH55GZ | Installation Instructions - Page 5
    Installation Instructions (C) VERTICAL EXHAUST: OUTSIDE VENTILATION 1. Remove and save 2 screws from the slits in the same direction as the arrow. Use 1 Tapping Screw 4 x 12 mm from the INSTALLATION HARDWARE and tighten into place. See Figure 15. (B) (A) Rotate 90˚ Figure 13 Figure 14 Exhaust Damper
  • Electrolux EI30MH55GZ | Installation Instructions - Page 6
    Installation Instructions 9 OVEN INSTALLATION THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON WALL AND TOP CABINET TEMPLATES. THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON WALL AND TOP CABINET TEMPLATES. THIS OVEN MUST BE ATTACHED TO AT
  • Electrolux EI30MH55GZ | Installation Instructions - Page 7
    Installation Instructions MOUNTING OVEN TO THE WALL Two people are recommended to attach the Over the Range Microwave Oven to the Mounting Plate. 1. Thread the power supply cord through the hole made in the bottom of the top cabinet. Install the oven by snapping it onto the Mounting Plate. See
  • Electrolux EI30MH55GZ | Installation Instructions - Page 8
  • Electrolux EI30MH55GZ | Installation Instructions - Page 9
    INSTRUCCIONES Horno microondas DE INSTALACIÓN sobre la estufa ANTES DE COMENZAR Lea estas instrucciones completa y detalladamente. • IMPORTANTE Guarde estas instrucciones para uso del inspector local. • IMPORTANTE Cumpla con los códigos y normas vigentes. • NOTA PARA EL INSTALADOR - Asegúrese de
  • Electrolux EI30MH55GZ | Installation Instructions - Page 10
    consulte a un electricista calificado o al encargado de servicio. 2. Ni Electrolux ni el distribuidor aceptan ninguna responsabilidad por los daños al horno La Figura 3 muestra la longitud equivalente aproximada en pies de algunas partes de ducto típicas. Utilice los valores dentro de los paréntesis
  • Electrolux EI30MH55GZ | Installation Instructions - Page 11
    ón del montante. 7 PREPARACIÓN DEL HORNO 1. Voltee el horno de costado. Vea la Figura 5. 2. Siga los pasos (A)-(D) para retirar la placa de montaje de la parte posterior del horno como se muestra en la Figura 5. (A) Retire la placa de montaje tirando de la palanquilla que está en la base del horno
  • Electrolux EI30MH55GZ | Installation Instructions - Page 12
    1. Retire 2 tornillos del borde posterior y 3 tornillos de la parte superior central del soporte de la cubierta del ventilador. Guarde 2 tornillos que los orificios de las paletas del ventilador estén frente a la parte posterior del horno. Vea la Figura 9 (A). Coloque nuevamente la unidad de
  • Electrolux EI30MH55GZ | Installation Instructions - Page 13
    ventilador de la campana. 3. Gire la unidad de ventilador de la campana 90˚ para que los orificios de las paletas del ventilador estén frente a la parte superior del horno. Vea la Figura 13 (A). Coloque nuevamente la unidad de ventilador de la campana en el horno. Tenga cuidado de no atrapar el
  • Electrolux EI30MH55GZ | Installation Instructions - Page 14
    Instrucciones de instalación 9 INSTALACIÓN DEL HORNO ESTE HORNO NO PUEDE INSTALARSE APROPIADAMENTE SI NO SE CONSULTAN LAS INSTRUCCIONES DE MONTAJE QUE SE ENCUENTRAN EN LAS PLANTILLAS DE PARED Y DEL GABINETE SUPERIOR. EL SIGUIENTE PASO ES LEER Y SEGUIR LA INFORMACIÓN DE MONTAJE QUE SE ENCUENTRA EN
  • Electrolux EI30MH55GZ | Installation Instructions - Page 15
    de alimentación a través del orificio hecho en la parte inferior del gabinete superior. Instale el horno presionándolo sobre la placa de montaje. Vea . Vea la Figura 22. 3 4 6 Figura 22 Figura 20 DIMENSIONES EXTERIORES Modelos EI30MH55GS/GB/GW: 29 29/32"(ancho) x 17 1/16"(alto) x 16 5/32
  • Electrolux EI30MH55GZ | Installation Instructions - Page 16
  • Electrolux EI30MH55GZ | Installation Instructions - Page 17
    poser par un électricien qualifié avant d'installer le four à microondes au-dessus d'une cuisinière. Voir 3 INSTRUCTIONS POUR LA MISE À LA TERRE É d'au moins 3/8 po (9,5 mm) d'épaisseur. Les surfaces de montage doivent pouvoir supporter un poids de 110 lb. (50 kg)- le four et son contenu - ET
  • Electrolux EI30MH55GZ | Installation Instructions - Page 18
    intégrée. Comme illustré par le schéma 2. Remarques : 1. Pour toute question à propos de l'installation électrique ou de la mise à la terre, consulter un électricien de métier ou un réparateur qualifié. 2. Ni Electrolux ni le détaillant ne peuvent être tenus responsables des dommages au four ou des
  • Electrolux EI30MH55GZ | Installation Instructions - Page 19
    Instructions D'Installation 6 MATÉRIEL D'INSTALLATION Les articles de quincaillerie du matériel d'installation 1 à 7 sont emballés dans un petit sac. Les articles 8 à " sont emballés séparément. L'ensemble de ces pièces est contenu dans un petit carton sous le
  • Electrolux EI30MH55GZ | Installation Instructions - Page 20
    fils. Voir le schéma 10A. 5. Fixer le registre d'évacuation au support du couvercle du ventilateur en le glissant dans les fentes dans la même D'INSTALLATION et serrer en place. Voir Figure 10B. 6. Cet ensemble sera monté dans le découpage arrière extérieur du registre dans des instructions ult
  • Electrolux EI30MH55GZ | Installation Instructions - Page 21
    Instructions D'Installation (C) Échappement vertical: Ventilation extérieure 1. Enlevez et conservez les 2 vis fentes dans le sens de la flèche. Utilisez 1 vis autotaraudeuse 5 de 4x12 mm du MATÉRIEL D'INSTALLATION et serrez en place (voir le Schéma 15). (A) Tournez 90˚ Schéma 12 (B) Schéma 13
  • Electrolux EI30MH55GZ | Installation Instructions - Page 22
    four CE FOUR NE PEUT PAS ÊTRE INSTALLÉ CORRECTEMENT SANS SE REPORTER AUX INSTRUCTIONS DE MONTAGE PORTÉES SUR LES GABARITS 16 PLAQUE DE MONTAGE 1. Séparez 4 boulons à bascule , emballés dans le MATÉRIEL d'INSTALLATION, des écrous à bascule. 2. Faites correspondre les trous de 5/8" (1,6 cm) percés au
  • Electrolux EI30MH55GZ | Installation Instructions - Page 23
    éma 22. 3 4 6 Schéma 22 Schéma 20 Dimensions extérieures EI30MH55GS/GB/GW: 22 9/16 po (L) x 10 9/16 po (H) x 15 po (P) PENSE-BÊTE POUR L'INSTALLATION 1. Assurez-vous que l'appareil a été installé en suivant toutes les instructions et en utilisant le gabarit mural et de plafond. 2. Branchez le
  • Electrolux EI30MH55GZ | Installation Instructions - Page 24
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
INSTALLATION
INSTRUCTIONS
Over the Range
Microwave Oven
±
E
± MOUNTING SPACE
This Over the Range Microwave Oven requires a mounting space
on a wall as shown in Figure 1. It is designed to be used with
standard 12" wall cabinets.
BEFORE YOU BEGIN
•
IMPORTANT
Save these instructions for local
inspector’s use.
•
IMPORTANT
Observe all governing codes and
coordinates.
•
NOTE TO INSTALLER
– Be sure to leave these
instructions with the Consumer.
•
NOTE TO CONSUMER
– Keep these instructions for
future reference.
•
SKILL LEVEL
– Installation of this appliance requires
basic mechanical and electrical skills.
•
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not covered
under the Warranty.
•
Please read all instructions thoroughly before installing
the Over the Range Microwave Oven. Two people are
recommended to install this product.
•
If a new electrical outlet is required, its installation should
be completed by a qualified electrician before the Over the
Range Microwave Oven is installed. See 3 ELECTRICAL
GROUNDING INSTRUCTIONS on page 2.
Read these instructions completely and carefully.
2 WALL CONSTRUCTION
This Over the Range Microwave Oven should be mounted against
and supported by a flat vertical wall. The wall must be flat for proper
installation. If the wall is not flat, use spacers to fill in the gaps. Wall
construction should be a minimum of 2" x 4" wood studding and
3/8" or more thick dry wall or plaster/lath. The mounting surfaces
must be capable of supporting weight of 110 pounds—the oven
and contents—AND the weight of all items which would normally
be stored in the top cabinet above the unit.
The unit should be attached to a minimum of one 2" x 4" wall
stud.
To find the location of the studs, one of the following methods may
be used:
A. Use a stud finder, a magnetic device which locates the nails in
the stud.
B. Use a hammer to tap lightly across the mounting surface to
find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with a
small nail to find the edges of the stud and then placing a mark
halfway between the edges. The center of any adjacent studs will
normally be 16" or 24" to either side of this mark.
NEED HELP?
For customers in the United States, call: 1-800-944-9044
For customers in Canada, call: 1-800-213-9397 (English)
1-800-668-4606 ext.8199 (French)
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
P/N 316495006
TINSEB484MRR0
Backsplash
Figure 1
15.5"
30" or more
from cooking
surface
66" or more
from floor
30"
At least 2"
12"