Epson PowerLite 1288 Warranty Statement

Supplier’s Declaration of Conformity

According to 47CFR, Part 2 and 15 for Class B Personal Computers and Peripherals; and/or CPU Boards and

Power Supplies used with Class B Personal Computers:

We: Epson America, Inc.

Located at: 3840 Kilroy Airport Way, MS 3-13, Long Beach, CA 90806-2469

Telephone: (562) 981-3840

Declare under sole responsibility that the product identified herein, complies with 47CFR Part 2 and 15 of the

FCC rules as a Class B digital device. Each product marketed, is identical to the representative unit tested and

found to be compliant with the standards. Records maintained continue to reflect the equipment being

produced can be expected to be within the variation accepted, due to quantity production and testing on a

statistical basis as required by 47CFR §2.906. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Trade Name: Epson

®

Type of Product: LCD Projector

Model: H981A/H982A/H983A/HA03A/H985A/H987A/H988A/H978A

Marketing Name: PowerLite

®

E20/X49/W49/118/119W/982W/992F/1288

Options: Remote controller (model 2198635xx [x=0–9])

Wireless LAN Safety and Specifications (PowerLite

992F/1288)

Contains wireless LAN module model: WLU5630B-D101(RoHS) and WLU5000-D101(RoHS)

This document provides safety instructions and describes the specifications. Read this document carefully

before use to ensure your safety and product performance.

Data transmission is always initiated by software, which is then passed down through the MAC, through the

digital and analog baseband, and finally to the RF chip. Several special packets are initiated by the MAC. These

are the only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the

end of the packet. Therefore, the transmitter will be on only while one of the aforementioned packets is being

transmitted. In other words, this device automatically discontinues transmission in case of either absence of

information to transmit or operational failure.

This equipment is restricted to indoor operation only.

U.S.

Contains FCC ID: BKMAE-WLU5630

Contains FCC ID: BKMAE-WLU5000

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.